Antibiotic-impregnated hip cement spacers of various types and materials have been used in the treatment of periprosthetic hip infections. We developed a handmade spacer by using polymethylmethacrylate (PMMA) and/or α-tricalcium phosphate (α-TCP). In this study, we retrospectively reviewed the surgical outcomes in 36 consecutive patients treated with 2-stage revision total hip arthroplasty by using our antibiotic-impregnated hip cement spacers. We aimed to analyze the infection control and reinfection rates after revision surgery. Moreover, we analyzed the possible predictors of postoperative reinfection. After exclusion of 1 patient who died immediately after the first-stage surgery, infection was controlled in 33 of the 36 hips (success rate, 91.7%). Two of these 33 hips underwent resection arthroplasty. Of the 36 hips that had been treated with the antibiotic-cement spacer, 31 hips (86.1%) were eligible for the second-stage prosthesis re-implantation. The 31 protocol hip joints of patients followed up for >6 months (mean, 48.6 months). Ten of these 31 hips (32.3%) became reinfected. No possible predictor examined differed significantly between the reinfection-positive and reinfection-negative groups. However, spacers consisting of PMMA cement alone were associated with the highest risk of reinfection. Therefore, α-TCP-containing antibiotic-impregnated hip cement spacers might decrease the reinfection rate in patients undergoing re-implantation.
We present the case of a 46-year-old woman who underwent revision surgery approximately 4 years after total hip arthroplasty because of a fracture of the modular neck of a MODULUS femoral stem. The fractured surfaces of the retrieved implant were inspected using optical and scanning electron microscopy. Three-dimensional finite element analysis was also performed to identify the stresses that might have caused the failure. We concluded that active, obese patients who are implanted with a high-offset, small-sized modular component could experience stress-induced fractures of the modular neck, with proper fixation and osseointegration of the distal stem, especially if residual bone or tissue is present on the inner surface of the neck that could contribute to micromovement and decreased proximal fixation.
BackgroundPrevious studies comparing antibiotic-loaded calcium phosphate cement to polymethylmethacrylate cement reported that although the former has higher elution volumes over a longer period, it is mechanically weak when used alone. To counter this problem, a double-layered antibiotic-loaded cement spacer in which calcium phosphate cement is coated with polymethylmethacrylate cement was created.MethodsIn this study, we compared the double-layered spacer to the polymethylmethacrylate cement spacer in terms of eluent antibiotic concentration, bioactivity against methicillin-resistant Staphylococcus aureus, and mechanical strength. Double-layered and polymethylmethacrylate cement spacers that were loaded with vancomycin (VCM) were prepared and immersed in phosphate buffer for 84 days. To facilitate VCM elution from calcium phosphate cores in double-layered spacers, we also drilled multiple holes into the calcium phosphate layer from the spacer surface.ResultsWe found that VCM concentrations in double-layered spacer eluents were higher than those in polymethylmethacrylate cement spacer eluents. The double-layered spacer also had higher bioactivity than the polymethylmethacrylate cement spacer. Although the polymethylmethacrylate cement spacer eluent lost the ability to inhibit bacterial growth on day 56, the double-layered spacer eluent maintained this ability for the duration of our study. Finally, the double-layered spacer retained high mechanical strength throughout the study period.ConclusionsThe beneficial biomechanical and drug-eluting properties of the double-layered spacer might qualify it to serve as a promising biomaterial that could be used for managing periprosthetic joint infections.
BackgroundTo identify whether hip arthroscopy is a suitable option for treating hip pain in elderly patients and investigate the clinical outcomes of hip arthroscopic surgery for labrum tear and/or osteoarthritis in patients over 50 years of age.MethodsBetween August 2009 and May 2014, a series of 23 patients (6 men and 17 women) with a mean age of 59 years underwent arthroscopy. We retrospectively examined the clinical records, radiographs, and outcome questionnaires from all patients. The mean follow-up period was 28 months.ResultsThe mean Japan Orthopedic Association hip score after surgery improved by a statistically significant amount. Eight patients (34.8%) were noted to have a progression of osteoarthritis (OA) diagnosed by radiograph, and one underwent THA after 13 months following arthroscopic surgery. The patients in which OA progression was noted were identified as having radiographical OA preoperatively and acetabular cartilage damage in the arthroscopic findings.ConclusionsArthroscopic surgery performed in selected patients over 50 years of age might be beneficial if classified as Tönnis grade 0 preoperatively and/or classified as Outerbridge grade II in the arthroscopic findings.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.