PurposeThe purpose of this study was to evaluate the clinical efficacy of enhancing deficient interdental papilla with hyaluronic acid gel injection by assessing the radiographic anatomical factors affecting the reconstruction of the interdental papilla.MethodsFifty-seven treated sites from 13 patients (6 males and 7 females) were included. Patients had papillary deficiency in the upper anterior area. Prior to treatment, photographic and periapical radiographic standardization devices were designed for each patient. A 30-gauge needle was used with an injection-assistance device to inject a hyaluronic acid gel to the involved papilla. This treatment was repeated up to 5 times every 3 weeks. Patients were followed up for 6 months after the initial gel application. Clinical photographic measurements of the black triangle area (BTA), height (BTH), and width (BTW) and periapical radiographic measurements of the contact point and the bone crest (CP-BC) and the interproximal distance between roots (IDR) were undertaken using computer software. The interdental papilla reconstruction rate (IPRR) was calculated to determine the percentage change of BTA between the initial and final examination and the association between radiographic factors and the reconstruction of the interdental papilla by means of injectable hyaluronic acid gel were evaluated.ResultsAll sites showed improvement between treatment examinations. Thirty-six sites had complete interdental papilla reconstruction and 21 sites showed improvement ranging from 19% to 96%. The CP-BC correlated with the IPRR. More specifically, when the CP-BC reached 6 mm, virtually complete interdental papilla reconstruction via injectable hyaluronic acid gel was achieved.ConclusionsThese results suggest that the CP-BC is closely related to the efficacy of hyaluronic acid gel injection for interdental papilla reconstruction.

We report generation and characterization of pain-related behavior in a minimally-invasive facet joint degeneration (FJD) animal model in rats. FJD was produced by a non-open percutaneous puncture-induced injury on the right lumbar FJs at three consecutive levels. Pressure hyperalgesia in the lower back was assessed by measuring the vocalization response to pressure from a force transducer. After hyperalgesia was established, pathological changes in lumbar FJs and alterations of intervertebral foramen size were assessed by histological and imaging analyses. To investigate treatment options for lumber FJ osteoarthritis-induced pain, animals with established hyperalgesia were administered with analgesic drugs, such as morphine, a selective COX-2 inhibitor, a non-steroidal anti-inflammatory drug (NSAID) (ketorolac), or pregabalin. Effects were assessed by behavioral pain responses. One week after percutaneous puncture-induced injury of the lumbar FJs, ipsilateral primary pressure hyperalgesia developed and was maintained for at least 12 weeks without foraminal stenosis. Animals showed decreased spontaneous activity, but no secondary hyperalgesia in the hind paws. Histopathological and microfocus X-ray computed tomography analyses demonstrated that the percutaneous puncture injury resulted in osteoarthritis-like structural changes in the FJs cartilage and subchondral bone. Pressure hyperalgesia was completely reversed by morphine. The administration of celecoxib produced moderate pain reduction with no statistical significance while the administration of ketorolac and pregabalin produced no analgesic effect on FJ osteoarthritis-induced back pain. Our animal model of non-open percutanous puncture-induced injury of the lumbar FJs in rats shows similar characteristics of low back pain produced by human facet arthropathy.

Background/purpose Due to the pneumatization of the maxillary sinus, the sinus floor augmentation is often performed to implant placement in the maxillary posterior region. The aim was to perform radiographic and histomorphometric evaluation after placement of mixed allografts (cortical freeze-dried bone allograft [FDBA] 50%:cancellous FDBA 50%) during sinus floor augmentation. Materials and methods In 37 patients, anorganic bovine bone (ABB, sites = 16), mineralized cancellous bone allograft (MCBA, sites = 15), and mixed allografts (Mixed AG, sites = 20) were placed during sinus floor elevation via the lateral approach (LSFE), at total 51 sites with residual alveolar bone height (RBH) < 5 mm. Cone-beam computed tomography images were obtained before LSFE (T0), after surgery (T1), and 6 months after surgery (T2) for radiographic analysis. After a 6-month healing period, core biopsies were harvested and histomorphometric analysis was performed. Results The mean augmented bone height (ABH) of ABB, MCBA, and mixed AG groups after surgery was similar (13.86 ± 4.19 mm, 13.99 ± 4.07 mm, and 14.20 ± 3.12 mm, respectively; P > 0.05). The mean ABH of ABB, MCBA, and mixed AG groups after 6 months was similar (13.72 ± 4.55 mm, 11.83 ± 3.31 mm, and 12.53 ± 2.97 mm, respectively; P > 0.05). In the ABB, MCBA, and mixed AG groups, the proportion of newly formed bone (NB) was similar (36.13 ± 10.01%, 39.26 ± 10.72%, and 31.27 ± 18.31%, respectively; P > 0.05). Conclusion This result demonstrated that mixed AG led to sufficient bone augmentation and histologically comparable NB formation as compared to ABB and MCBA for sinus floor augmentation.