Metal oxide coatings can improve the electrochemical stability of cathodes and hence, their cycle-life in rechargeable batteries. However, such coatings often impose an additional electrical and ionic transport resistance to cathode surfaces leading to poor charge-discharge capacity at high C-rates. Here, a mixed oxide (Al2O3)1-x(Ga2O3)x alloy coating, prepared via atomic layer deposition (ALD), on Li[Ni0.5Mn0.3Co0.2]O2 (NMC) cathodes is developed that has increased electron conductivity and demonstrated an improved rate performance in comparison to uncoated NMC. A "co-pulsing" ALD technique was used which allows intimate and controlled ternary mixing of deposited film to obtain nanometer-thick mixed oxide coatings. Co-pulsing allows for independent control over film composition and thickness in contrast to separate sequential pulsing of the metal sources. (Al2O3)1-x(Ga2O3)x alloy coatings were demonstrated to improve the cycle life of the battery. Cycle tests show that increasing Al-content in alloy coatings increases capacity retention; whereas a mixture of compositions near (Al2O3)0.5(Ga2O3)0.5 was found to produce the optimal rate performance.

TiO2-coated Co/C catalysts prepared by atomic layer deposition (ALD) were used to study the effect of TiO2 overcoating on a Co/C catalyst for electrochemical water oxidation. The Co/C catalyst with a thin-layer overcoating of TiO2 (ALD­(TiO2)-Co/C) demonstrated 2.5 times higher turnover frequency (TOF) than the Co/C catalyst for the reaction. The TOF of the ALD­(TiO2)-Co/C catalyst increased when the ALD­(TiO2) coating cycle number was increased from 5 to 60. In addition, the stability of the 60 cycle ALD­(TiO2)-Co/C catalyst was enhanced compared to the Co/C catalyst. This work shows how the ALD synthesis technique can be used to improve the catalytic activity and stability of nonprecious-metal-based catalysts like Co/C for electrochemical water oxidation.

Integration of emerging complex-oxide compounds into sophisticated nanoscale single-crystal geometries faces significant challenges arising from the kinetics of vapor-phase thin-film epitaxial growth. A comparison of the crystallization of the model perovskite SrTiO (STO) on (001) STO and oxidized (001) Si substrates indicates that there is a viable alternative route that can yield three-dimensional epitaxial synthesis, an approach in which STO is crystallized from an amorphous thin film by postdeposition annealing. The crystallization of amorphous STO on single-crystal (001) STO substrates occurs via solid-phase epitaxy (SPE), without nucleation and with a temperature-dependent amorphous/crystalline interface velocity. In comparison, the crystallization of STO on SiO/(001) Si substrates requires nucleation, resulting in a polycrystalline film with crystal sizes on the order of 10 nm. A comparison of the temperature dependence of the nucleation and growth processes for these two substrates indicates that it will be possible to create crystalline STO materials using low-temperature crystallization from a crystalline seed, even in the presence of interfaces with other materials. These processes provide a potential route for the formation of single crystals with intricate three-dimensional nanoscale geometries.

No abstract

No abstract