No abstract

No abstract

Rainwater-harvesting (RWH) agriculture has been accepted as an effective approach to easing the overexploitation of groundwater and the associated socioeconomic impacts in arid and semiarid areas. However, the stability and reliability of the traditional methods for selecting optimal sites for RWH agriculture need to be further enhanced. Based on a case study in Tehran Province, Iran, this study proposed a new decision support system (DSS) that incorporates the Best-Worst Method (BWM) and Fuzzy logic into a geographic information system (GIS) environment. The probabilistic analysis of the rainfall pattern using Monte Carlo simulation was conducted and adopted in the DSS. The results have been demonstrated using suitability maps based on three types of RWH systems, i.e., pans and ponds, percolation tanks, and check dams. Compared with traditional methods, the sensitivity analysis has verified that the proposed DSS is more stable and reliable than the traditional methods. Based on the results, a phase-wise strategy that shifts the current unsustainable agriculture to a new paradigm based on RWH agriculture has been discussed. Therefore, this DSS has enhanced the information value and thus can be accepted as a useful tool to ease the dilemma resulting from unsustainable agriculture in arid and semiarid areas.

Current centralized urban water supply depends largely on energy consumption, creating critical water-energy challenge especially for many rapid growing Asian cities. In this context, harvesting rooftop rainwater for non-potable use has enormous potential to ease the worsening water-energy issue. For this, we propose a geographic information system (GIS)-simulation-based design system (GSBDS) to explore how rainwater harvesting systems (RWHSs) can be systematically and cost-effectively designed as an innovative water-energy conservation scheme on a city scale. This GSBDS integrated a rainfall data base, water balance model, spatial technologies, energy-saving investigation, and economic feasibility analysis based on a case study of eight communities in the Taipei metropolitan area, Taiwan. Addressing both the temporal and spatial variations in rainfall, the GSBDS enhanced the broad application of RWHS evaluations. The results indicate that the scheme is feasible based on the optimal design when both water and energy-savings are evaluated. RWHSs were observed to be cost-effective and facilitated 21.6% domestic water-use savings, and 138.6 (kWh/year-family) energy-savings. Furthermore, the cost of per unit-energy-saving is lower than that from solar PV systems in 85% of the RWHS settings. Hence, RWHSs not only enable water-savings, but are also an alternative OPEN ACCESSWater 2015, 7 6286 renewable energy-saving approach that can address the water-energy dilemma caused by rapid urbanization.

No abstract

Green roof systems have been suggested to ease the growing urban environmental problems resulting from rapid urbanization. However, the irrigation of green roofs heavily depends on using precious potable water and consequently generates negative environmental effects. Rainwater has been recommended to address this dilemma, but the design method has not been well developed. In this study, the major design factors of a rainwater harvesting system for green roof irrigation systems are examined, and a simulation-based mathematical model is established to elucidate the correlation between tank volume and system performance. The optimal system design and probability distribution of the potable water replacement rate are also discussed on the basis of a case study of a university building in Keelung, Northern Taiwan. The results show that the optimal tank volume, potable water replacement rate, and probability of exceedance are 9.41 m 3 , 92.72%, and 88.76% (±1SD), respectively. In addition, the economic performance is identified to be feasible. Hence, the design method has been verified to be a useful tool to ease the urban environmental issues.

No abstract

No abstract