The diameter, membrane thickness, and compression intensity of hollow Ca-alginate capsules were measured at different gelation conditions, such as the reactant concentration, dropping velocity, and gelation time. The optimum operation conditions for preparing capsules were determined at 100 g/L CaCl(2), 10 g/L sodium alginate (Na-alginate), a dropping velocity of 150 droplets/min, and a gelation time of 10 min. Diffusion of some saccharide and amino acid from bulk solution into capsules was investigated, and the diffusion coefficients were calculated by the developed mathematical model. All the tested substances can diffuse easily into the capsules. The combined diffusion coefficients of the capsule D(m) are 92-99% as large as their diffusion coefficients in pure water, while the diffusion coefficients in the capsule membrane D(1) are 60-95% as large as those. By employing polyethylene glycol (PEG) and bovine serum albumin (fraction V) (BSA(V)), the molecular weight cut-off of the capsule was determined. For linear macromolecules, hollow Ca-alginate capsules have a molecular weight cut-off of 4000. No diffusion of BSA(V) into the capsules was observed.
Intrahollow calcium alginate microcapsules were prepared with sodium alginate (SA) of different
concentrations. Using a well-mixed and temperature-controlled vessel, the diffusivities of glucose, lactose,
tyrosine, glutamic acid, lysine, and phenylalanine from bulk solution into the microcapsules were
investigated and the diffusion coefficients were also calculated. The results indicate that all these
substrates tested can diffuse easily through the microcapsule. The combined diffusion coefficients (D
m)
are 2%−12% smaller than the diffusion coefficients in pure water while the diffusion coefficients in the
microcapsule membrane (D
1) are 50%−94% smaller than those. In all cases, the diffusion coefficients are
hardly affected by SA concentrations ranging from 8 g·L-1 to12 g·L-1 used in preparing the microcapsules.
In this study, a novel cellulose/Ag/TiO2 nanocomposite was successfully synthesized via the hydrothermal method. The cellulose extracted from oil palm empty fruit bunch (OPEFB) could address the disposal issue created by OPEFB biomass. Characterization studies such as FESEM, EDX, HRTEM, XRD, FTIR, UV–Vis DRS, PL, XPS, and surface analysis were conducted. It was observed that the incorporation of cellulose could hinder the agglomeration, reduce the band gap energy to 3 eV, increase the specific surface area to 150.22 m3/g, and lower the recombination rate of the generated electron-hole pairs compared to Ag/TiO2 nanoparticles. The excellent properties enhance the sonocatalytic degradation efficiency of 10 mg/L Congo red (up to 81.3% after 10 min ultrasonic irradiation) in the presence of 0.5 g/L cellulose/Ag/TiO2 at 24 kHz and 280 W. The improvement of catalytic activity was due to the surface plasmon resonance effect of Ag and numerous hydroxyl groups on cellulose that capture the holes, which delay the recombination rate of the charge carriers in TiO2. This study demonstrated an alternative approach in the development of an efficient sonocatalyst for the sonocatalytic degradation of Congo red.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.