To enhance actuation performance without prestrain, an elastomeric acrylic triblock copolymer, poly(methyl methacrylate)block-poly(n-butyl acrylate)-block-poly(methyl methacrylate), was modified with two kinds of additives, oligomeric poly(n-butyl acrylate) and the plasticizer dibutyl sebacate. An actuator modified with those additives showed about 6% strain, whereas the unmodified actuator showed only 1% strain for the same applied electric field without prestrain. In addition, actuation was attained at lower critical electric field strength (625 and 1000 V mm −1 for modified and unmodified actuators, respectively). Upon increasing the amounts of the additives, the electrically induced actuation velocity and degree of deformation increased. These results are explained by the dielectric and mechanical properties of the elastomers. The dielectric constants for elastomers modified with dibutyl sebacate were larger than those for elastomers modified with oligomeric poly(n-butyl acrylate). The initial tensile stresses of both of the modified elastomers were much smaller than that of unmodified elastomer. The results provide a route to enhancing actuation performance of dielectric elastomers without prestrain.
Block copolymers posses inherently the ability of form a variety of phase-separated microdomain structures. The lengths of block segments and the selectivity of the solvent are primary factors affecting the resultant morphology. This paper investigated the effect of casting solvents on the morphologies and electrical actuation of poly(methyl methacrylate)-poly(n-butyl acrylate)-poly(methyl methacrylate) (PMMA-PnBA-PMMA) triblock copolymer films comprising PMMA hard segment and PnBA soft segment. Transmission electron microscopy and confocal laser scanning microscopy observation revealed that PMMA and PnBA segments were assembled into various micro- and nano-sized phase structures where either of them formed continuous phase. This implies that continous phase could be inversed by used casting solvents. Solvent-dependent phase morphologies had a significant effect on the electrical actuation results. Increase of the PnBA contents and the continuous phases of PnBA soft segments improved both of electrical actuation and dielectric constant, indicating that solvent-induced phase separation modulates the electrical actuation of dielectric films. The significance of the role of solvent selectivity and the major continuous phase of the polymer in defining the morphology and electrical actuation of the self-assembled block copolymer structure are discussed
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.