Work function engineering of two-dimensional (2D) materials by application of polymer coatings represents a research thrust that promises to enhance the performance of electronic devices. While polymer zwitterions have been demonstrated to significantly modify the work function of both metal electrodes and 2D materials due to their dipole-rich structure, the impact of zwitterion chemical structure on work function modulation is not well understood. To address this knowledge gap, we synthesized a series of sulfobetaine-based zwitterionic random copolymers with variable substituents and used them in lithographic patterning for the preparation of negative-tone resists (i.e., "zwitterists") on monolayer graphene. Ultraviolet photoelectron spectroscopy indicated a significant work function reduction, as high as 1.5 eV, induced by all polymer zwitterions when applied as ultrathin films (<10 nm) on monolayer graphene. Of the polymers studied, the piperidinyl-substituted version, produced the largest dipole normal to the graphene sheet, thereby inducing the maximum work function reduction. Density functional theory calculations probed the influence of zwitterion composition on dipole orientation, while lithographic patterning allowed for evaluation of surface potential contrast via Kelvin probe force microscopy. Overall, this polymer "zwitterist" design holds promise for fine-tuning 2D materials electronics with spatial control based on the chemistry of the polymer coating and the dimensions of the lithographic patterning.

Graphene holds promise for thin, ultralightweight, and high‐performance nanoelectromechanical transducers. However, graphene‐only devices are limited in size due to fatigue and fracture of suspended graphene membranes. Here, a lightweight, flexible, transparent, and conductive bilayer composite of polyetherimide and single‐layer graphene is prepared and suspended on the centimeter scale with an unprecedentedly high aspect ratio of 105. The coupling of the two components leads to mutual reinforcement and creates an ultrastrong membrane that supports 30 000 times its own weight. Upon electromechanical actuation, the membrane pushes a massive amount of air and generates high‐quality acoustic sound. The energy efficiency is ≈10–100 times better than state‐of‐the‐art electrodynamic speakers. The bilayer membrane's combined properties of electrical conductivity, mechanical strength, optical transparency, thermal stability, and chemical resistance will promote applications in electronics, mechanics, and optics.

We investigated the nature of graphene surface doping by zwitterionic polymers and the implications of weak in-plane and strong through-plane screening using a novel sample geometry that allows direct access to either the graphene or the polymer side of a graphene/polymer interface. Using both Kelvin probe and electrostatic force microscopies, we observed a significant upshift in the Fermi level in graphene of ∼260 meV that was dominated by a change in polarizability rather than pure charge transfer with the organic overlayer. This physical picture is supported by density functional theory (DFT) calculations, which describe a redistribution of charge in graphene in response to the dipoles of the adsorbed zwitterionic moieties, analogous to a local DC Stark effect. Strong metallic-like screening of the adsorbed dipoles was observed by employing an inverted geometry, an effect identified by DFT to arise from a strongly asymmetric redistribution of charge confined to the side of graphene proximal to the zwitterion dipoles. Transport measurements confirm n-type doping with no significant impact on carrier mobility, thus demonstrating a route to desirable electronic properties in devices that combine graphene with lithographically patterned polymers.