To address the difficult problems in the study of the effect of average strain on fatigue life under low-cycle fatigue loads, the effect of average strain on the low-cycle fatigue life of materials under different strain cycle ratios was discussed based on the framework of damage mechanics and its irreversible thermodynamics. By introducing the Ramberg-Osgood cyclic constitutive equation, a new low-cycle fatigue life prediction method based on the intrinsic damage dissipation theory considering average strain was proposed, which revealed the correlation between low-cycle fatigue strain life , material properties, and average strain. Through the analysis of the low-cycle fatigue test data of five different metal materials, the model parameters of the corresponding materials were obtained. The calculation results indicate that the proposed life prediction method is in good agreement with the test, and a reasonable characterization of the low-cycle fatigue life under the influence of average strain is realized. Comparing calculations with three typical low-cycle fatigue life prediction models, the new method is within two times the error band, and the prediction effect is significantly better than the existing models, which is more suitable for low-cycle fatigue life prediction. The low-cycle fatigue life prediction of different cyclic strain ratios based on the critical region intrinsic damage dissipation power method provides a new idea for the research of low-cycle fatigue life prediction of metallic materials.
The structural parts of construction machinery mostly fail due to impact load, but current research on the failure behavior of the impact load has not established a complete theoretical system. Based on wave theory and fracture mechanics, this paper analyzed the wave behavior of shock stress waves and established a model of shock stress wave propagation. Given the dynamic response behavior of the stress and strain field at the crack tip, dynamic fracture mechanics theory was used to solve the dynamic fracture strength stress factor and evaluate the dynamic fracture performance of the structure with crack damage under shock waves. Through dynamic response analysis and numerical calculation of the typical SHPB (split Hopkinson pressure bar) test standard compact tension (CT) specimens under the short-term strong shock stress wave, the stress and strain evolution law of the material under the shock wave was analyzed, and the correlation of the shock stress wave was verified. This research work can meet the requirements of engineering design and has practical engineering significance, playing an important role in material safety design.
In the process of copper alloy hot continuous rolling, the problem of copper sticking to the roller seriously affects the surface quality, performance, and service life of the copper products. Roll sticking occurs as the adhesion energy of Cu is lower than that of Fe and the Fe-Cu interface, and the severe surface deformation which forces the copper into direct contact with the roll during the process of profile rolling. Based on the copper deformation law and adhesion phenomenon in the hot continuous rolling process, a rolling deformation model and roll copper adhesion model or copper alloy hot continuous rolling were established, and their simulation was realized using finite element software. Through finite element modeling of the hot rolling deformation zone, the distribution of the temperature, contact normal stress, and exposure rate in the hot rolling deformation zone were obtained, which were consistent with the actual roll adhesion phenomenon and copper adhesion position. To address the copper sticking behavior of the rolls, the process optimization method of matching the motor speed with the elongation coefficient (the 1# and 2# motor speeds were adjusted to 1549 r/min and 1586 r/min, respectively), adjusting the roll gap to 7.9 mm, and increasing the number and pressure of roll spray nozzles were put forward, which effectively solved the problem of copper sticking to the roll, significantly improved the surface quality of the copper and the service life of the roll, and can be used in production.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.