This study focuses on the machined surface integrity of the titanium alloy Ti-10V-2Fe-3Al (Ti-1023) during face milling. Surface roughness, machining defect, microhardness, and microstructure variations are investigated at different cutting speeds and tool average flank wear (VB) values. Experimental results show that surface roughness increases when cutting speed is increased from 40 to 100 m min −1 and decreases when cutting speed is increased from 100 to 300 m min −1 by using a new tool. Moreover, surface roughness values are stable when cutting speed is increased by using a worn tool at VB =0.2 mm and increases when VB is increased. As for defects, the machining defect is determined to be dependent on cutting speed and tool wear directions. Microhardness is decreased to 35 μm beneath the machined surface at different cutting speeds by using a new tool. The influence of tool wear on hardening is significant, with the depth of hardening being less than 55 μm by using a worn tool at VB=0.2 mm and reaching 130 μm at VB=0.35 mm. No significant phase transformation or evident deformation can be observed at different cutting speeds by using a new tool (initial wear). Severe plastic deformation and deep alteration of the microstructure in the machined surface are produced with VB from initial wear to VB=0.35 mm. VB is best maintained at less than 0.2 mm for finish machining of Ti-1023.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.