Abstract:Subways have been an important method for relieving traffic pressures in urban areas, but ground subsidence, during construction and operation, can be a serious problem as it may affect the safety of its operation and that of the surrounding buildings. Thus, conducting long-term ground deformation monitoring and modeling for subway networks are essential. Compared with traditional geodetic methods, the Persistent Scatterer Interferometric Synthetic Aperture Radar (PS-InSAR) technique offers wider coverage and denser measurements along subway lines. In this study, we mapped the surface deformation of the Guangzhou subway network with Advanced Synthetic Aperture Radar (ASAR) and Phased Array Type L-band Synthetic Aperture Radar (PALSAR) data using the Interferometric Point Target Analysis (IPTA) technique. The results indicate that newly excavated tunnels have regional subsidence with an average rate of more than 8 mm/year, as found on Lines Two, Three, Six, and GuangFo (GF). Furthermore, we determined the spatio-temporal subsidence behavior of subways with PALSAR in delta areas using Peck's formula and the logistic time model. We estimated the tunneling-related parameters in soft soil areas, which had not been previously explored. We examined a section of line GF, as an example, to estimate the ground settlement trough development. The results showed the maximum settlement increased from −5.2 mm to −23.6 mm and its ground loss ratio ranged from 1.5-8.7% between 13 July 2008 and 19 January 2011. In addition, we found that the tunnels in line GF will become stable after a period of about 2300 days in peak subsidence areas. The results show that the proposed approach can help explain the dynamic ground subsidence along a metro line. This study can provide references for urban subway projects in delta areas, and for the risk assessment of nearby buildings and underground pipelines along metro lines.

Abstract:Because of the advantages of low cost, large coverage and short revisit cycle, Landsat 8 images have been widely applied to monitor earth surface movements. However, there are few systematic studies considering the error source characteristics or the improvement of the deformation field accuracy obtained by Landsat 8 image. In this study, we utilize the 2013 Mw 7.7 Balochistan, Pakistan earthquake to analyze error spatio-temporal characteristics and elaborate how to mitigate error sources in the deformation field extracted from multi-temporal Landsat 8 images. We found that the stripe artifacts and the topographic shadowing artifacts are two major error components in the deformation field, which currently lack overall understanding and an effective mitigation strategy. For the stripe artifacts, we propose a small spatial baseline (<200 m) method to avoid the stripe artifacts effect on the deformation field. We also propose a small radiometric baseline method to reduce the topographic shadowing artifacts and radiometric decorrelation noises. Those performances and accuracy evaluation show that these two methods are effective in improving the precision of deformation field. This study provides the possibility to detect subtle ground movement with higher precision caused by earthquake, melting glaciers, landslides, etc., with Landsat 8 images. It is also a good reference for error source analysis and corrections in deformation field extracted from other optical satellite images.

Abstract:The Tsaoling Landslide in Taiwan has captured attentions of researchers worldwide due to its frequent catastrophic failure and distinctive features. Thanks to the launch of TerraSAR-X/TanDEM-X (TSX/TDX) constellation, retrieval of global DEM with high spatial resolution and accuracy becomes possible, which is extremely useful for the study of natural hazards (e.g., landslides) globally. We attempt here for the first time to track recent landslide movements in Tsaoling Taiwan by analyzing DEM time series reconstructed from TSX/TDX image pairs. Quality improvement of InSAR derived DEM through an iterated differential operation is addressed during the data processing.

Coastal areas are usually densely populated, economically developed, ecologically dense, and subject to a phenomenon that is becoming increasingly serious, land subsidence. Land subsidence can accelerate the increase in relative sea level, lead to a series of potential hazards, and threaten the stability of the ecological environment and human lives. In this paper, we adopted two commonly used multi-temporal interferometric synthetic aperture radar (MTInSAR) techniques, Small baseline subset (SBAS) and Temporarily coherent point (TCP) InSAR, to monitor the land subsidence along the entire coastline of Guangdong Province. The long-wavelength L-band ALOS/PALSAR-1 dataset collected from 2007 to 2011 is used to generate the average deformation velocity and deformation time series. Linear subsidence rates over 150 mm/yr are observed in the Chaoshan Plain. The spatiotemporal characteristics are analyzed and then compared with land use and geology to infer potential causes of the land subsidence. The results show that (1) subsidence with notable rates (>20 mm/yr) mainly occurs in areas of aquaculture, followed by urban, agricultural, and forest areas, with percentages of 40.8%, 37.1%, 21.5%, and 0.6%, respectively; (2) subsidence is mainly concentrated in the compressible Holocene deposits, and clearly associated with the thickness of the deposits; and (3) groundwater exploitation for aquaculture and agricultural use outside city areas is probably the main cause of subsidence along these coastal areas.

No abstract

No abstract

Synthetic aperture radar tomography (TomoSAR) has been proven to be a useful way to reconstruct vertical structure over forest areas with P-band images, on account of its three-dimensional imaging ability. In the case of a small number of non-uniformly distributed acquisitions, compressive sensing (CS) is generally adopted in TomoSAR. However, the performance of CS depends on the selected hyperparameter, which is closely related to the noise of a pixel. In this paper, to overcome this limitation, we propose a sparse iterative covariance-based estimation (SPICE) approach based on the wavelet and orthogonal sparse basis (W&O-SPICE) for application over forest areas. SPICE is a sparse spectral estimation method that achieves a high vertical resolution, and takes account of the noise adaptively for each resolution cell. Thus, it does not require the user to select a hyperparameter. Furthermore, the used sparse basis not only ensures the sparsity of the forest canopy scattering contribution, but it can also keep the original sparse information of the ground contribution. The proposed method was tested in simulated experiments and the results demonstrated that W&O-SPICE can successfully reconstruct the vertical structure of a forest. Moreover, three P-band fully polarimetric airborne SAR images with non-uniformly distributed baselines were applied to reconstruct the vertical structure of a tropical forest in Mabounie, Gabon. The underlying topography and forest height were estimated, and the root-mean-square errors (RMSEs) were 6.40 m and 4.50 m with respect to the LiDAR digital terrain model (DTM) and canopy height model (CHM), respectively. In addition, W&O-SPICE showed a better performance than W&O-CS, beamforming, Capon, and the iterative adaptive approach (IAA).

Synthetic aperture radar tomography (TomoSAR) is a useful tool for retrieving the three-dimensional structure of buildings in urban areas, especially for datasets with a high spatial resolution. However, among the previous TomoSAR estimators, some cannot retrieve the 3-D structure of objects with a high elevation resolution, some cannot maintain the spatial resolution, and some require the selection of a hyperparameter. To overcome these limitations, this paper proposes a new nonparametric iterative adaptive approach with a model selection tool based on the Bayesian information criterion (IAA-BIC) for the application of TomoSAR in urban areas. IAA-BIC employs weighted least squares to acquire a high elevation resolution and works well for both distributed and coherent scatterers, even with single-look. Concurrently, IAA-BIC does not require the user to make any difficult selection regarding a hyperparameter. The proposed IAA-BIC estimator was tested in simulated experiments, and the results confirmed the advantages of the IAA-BIC estimator. Moreover, the three-dimensional structure of the Hubei Science and Technology Venture building in Wuhan, China, was retrieved through the IAA-BIC method with nine very high spatial resolution TerraSAR-X images. The height estimation accuracy for this building was about 1% and 4% relative to its real height for single-look and multi-look, respectively. In addition, a comparison between the IAA-BIC estimator and some of the typical existing TomoSAR estimators (Capon, MUSIC, and compressed sensing (CS)) was also carried out. The results indicate that the IAA-BIC estimator obtains a better resolution for coherent sources than Capon and MUSIC; notably, the IAA-BIC estimator obtains a similar performance to CS, but in less computation time.