Characteristics of mosquito larval habitats are important in determining whether they can survive and successfully complete their developmental stages. Therefore, data on the ecological factors affecting mosquito density and abundance especially the physicochemical properties of water of their breeding sites, can possibly be helpful in implementing larval management programs. Mosquito larvae were collected using a standard 350 ml dipper from fixed habitats including: artificial pool, river edge, creek and etc, in 30 villages of 16 counties from May-December 2014. Water samples were collected during larval collection and temperature (°C), acidity (pH), turbidity (NTU), electrical conductivity (μS/cm), alkalinity (mg/l CaCO3), total hardness (mg/l), nitrate (mg/l), chloride (mg/l), phosphate (mg/l) and sulphate (mg/l) were measured using standard methods. Spearman correlation coefficient, Kruskal-Wallis test of nonparametric analysis, Chi-square (χ2) analysis, regression analysis and C8 interspecific correlation coefficient were used for data analysis. A total of 7,566 mosquito larvae belonging to 15 species representing three genera were collected from fixed larval breeding places. Culex pipiens was the dominant species except in four villages where An. maculipennis s.l. and Cx. torrentium were predominant. There was a significant positive correlation between the density of Cx. pipiens and electrical conductivity, alkalinity, total hardness and chloride, whereas no significant negative correlation was observed between physicochemical factors and larval density. The highest interspecific association of up to 0.596 was observed between An. maculipennis s.l/An. pseudopictus followed by up to 0.435 between An. maculipennis s.l/An. hyrcanus and An. hyrcanus/An. pseudopictus. The correlations observed between physicochemical factors and larval density, can possibly confirm the effect of these parameters on the breeding activities of mosquitoes, and may be indicative of the presence of certain mosquito fauna in a given region.
Olive mill wastewater is considered as one of the most polluting effluents of the food industry and constitutes a source of important environmental problems. In this study, the removal of pollutants (chemical oxygen demand (COD), biochemical oxygen demand (BOD5), polyphenols, turbidity, color, total suspended solids (TSS), and oil and grease) from olive oil mill processing wastewater by peroxi-electrocoagulation/electrooxidation-electroflotation process with bipolar aluminum electrodes was evaluated using a pilot continuous reactor. In the electrochemical unit, aluminum (Al), stainless steel, and RuO2/Ti plates were used. The effects of pH, hydrogen peroxide doses, current density, NaCl concentrations, and reaction times were studied. Under optimal conditions of pH 4, current density of 40 mA/m(2), 1000 mg/L H2O2, 1 g/L NaCl, and 30-min reaction time, the peroxi-electrochemical method yielded very effective removal of organic pollution from the olive mill wastewater diluted four times. The treatment process reduced COD by 96%, BOD5 by 93.6%, total, polyphenols by 94.4%, color by 91.4%, turbidity by 88.7, suspended solids by 97% and oil and grease by 97.1%. The biodegradability index (BOD5/COD) increased from 0.29 to 0.46. Therefore, the peroxi-electrocoagulation/electrooxidation-electroflotation process is considered as an effective and feasible process for pre-treating olive mill wastewater, making possible a post-treatment of the effluent in a biological system.
Background: Manganese (Mn) used as raw material for melting process in the ferrous foundry is considered as hazardous neurotoxic substance because it accumulates in the central nervous system and may cause neurological disorders. The furnace-men and melting department workers are potentially exposed to manganese particles or fume in the workplace. The objective of the research has been to investigate the sources and levels of manganese exposure in the foundry by correlation of blood-manganese (B-Mn) and air-manganese (air-Mn) measurement. Material and Methods: Air-Mn and Mn of blood serum were measured involving workers who worked in a big-sized foundry during 1 year. The standard method of the Occupational Safety and Health Administration (OSHA) ID-121 was used for air and blood assessment and atomic absorption spectroscopy (AAS) was carried out for air and blood sample analysis. Results: The air sampling results have revealed that there is a high exposure to manganese (4.5 mg/m 3 ) in the workplace as compared to the National Institute for Occupational Safety and Health's (NIOSH) time weighted average (the reference time-weighted average (TWA) = 1 mg/m 3 ). The average blood serum Mn concentration was 2.745 μg/l for subjects working for shorter than 3 months and 274.85 μg/l for subjects working 3-12 months. Conclusions: Against the research hypothesis there was no correlation between the air-Mn concentration and the B-Mn (serum) level of manganese in the serum of the exposed subjects. It may be due to short time of air sampling of manganese airborne particles, and a real-time monitoring of airborne manganese particles is suggested for any future study. Med Pr 2017;68(4): [449][450][451][452][453][454][455][456][457][458]
The present study evaluated the treatment of hospital wastewater by the electrocoagulation process using aluminum and iron electrodes. The effects of pH, voltage and reaction time on the removal efficiencies of the antibiotic cefazolin, chemical oxygen demand (COD) and turbidity were investigated. The results showed that by increasing reaction time and input voltage, the removal efficiency of pollutants was increased. The highest removal efficiency of cefazolin, COD, and turbidity occurred at neutral pH, which may have been related to the formation of aluminum hydroxide (Al (OH)3) flocs through the combination of aluminum released from the surface of the electrode and the hydroxide ions present in the solution. The conductivity of the treated wastewater at neutral to alkaline pH decreased compared to acidic pH, which may have been due to the adsorption of anions and cations from the solution by the Al(OH)3 flocs. The electrode and energy consumption in the present study was higher than in other studies, which may have been due to the high concentration of COD in and the turbidity of the solution.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.