Energy harvesting from human body motion has been investigated extensively in the last two decades due to the increasing demand for Smart Wearables. Smart Wearables are beneficial in terms of daily monitoring of vital parameters and early recognition of diseases. However, continuous and close-meshed monitoring in daily life is often facing the obstacle of limited energy storage. Integrated sensors and electronics of Smart Wearables may be powered in a conventional manner by energy storage. But energy storage such as battery is subject to restrictions as limited lifetime and charging process. Thus, the development of self-powering Smart Wearables is highly promising. The conversion of human body motion into electrical energy is significant for the identification of medical application areas. Investigations on energy harvesting from human body motion is facing limitations such as low frequency range of body motion, low accelerations as well as wearing comfort. Numerous studies address the use of piezoelectric ceramics for energy harvesting. However, the high mass density and the high modulus of elasticity limit energy harvester designs based on piezoelectric ceramics to rather heavy wearables. In terms of lightweight designs, polymers such as PVDF (polyvinylidene fluoride) have been considered as functional materials in several researches but these materials are disadvantageous regarding energy efficiency. Auspicious functional materials for energy harvesting from body motion are piezoelectric electrets (piezoelectrets, also referred to as ferroelectrets) due to their high piezoelectric coefficients and low mass density. Piezoelectrets facilitate the implementation of lightweight energy harvester designs with high output power that is advantageous for applications in context of Smart Wearables. In particular, fluorethylpolypropylene (FEP) piezoelectrets with parallel-tunnel structures are promising generators for energy harvesting. Within the present work, a novel design of parallel-tunnel FEP energy harvester in 31-mode is introduced and validated by means of an experimental setup.
In this publication the application of novel piezoelectric materials for energy harvesting on vibrating aircraft structures is investigated. These materials have significant advantages over conventional piezoelectric transducer materials like piezoceramics. In particular, biogenic materials in the form of wood-based materials and ferroelectrets in the form of irradiation cross-linked polypropylene are the subject of the investigation. The material characterization in terms of mechanical and electromechanical properties is shown for both material types. For the wood materials a compression test is used as the material has load-bearing properties. The ferroelectrets provide high compliances and are therefore investigated in a tensile test for material characterisation as well as in a four-point flexural test regarding its behaviour when glued to a dynamically bending surface. Additionally an FE-model of the material model for ferroelectrets is presented, which is validated by experimental results. An estimation of the power output is given for different concepts with both kinds of materials.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.