Magnetotelluric and seismological studies suggested the presence of partial melts in the middle to lower Himalaya-Tibetan crust. However, the melt fractions inferred by previous work were based on presumed electrical conductivity of melts. We performed measurements on the electrical conductivity of peraluminous granitic melts with 0.16-8.4 wt % H 2 O (the expected compositions in the Tibetan crust) at 600-1,300°C and 0.5-1.0 GPa. Peraluminous melt exhibits lower electrical conductivity than peralkaline melt at dry condition, but this difference diminishes at H 2 O > 2 wt %. With our data, the observed electrical anomalies in the Tibetan crust could be explained by 2-33 vol % of peraluminous granitic melts with H 2 O > 6 wt %. Possible reasons for our inferred melt fractions being higher than seismological constraints include the following: (1) The real melts are more Na and H 2 O rich, (2) the effect of melt reducing seismic velocities was overestimated, and (3) the anomalies at some locations are due to fluids. Plain Language SummaryWhether there are molten zones present in the Tibetan crust is a focus of geophysical and petrological research. Previous interpretations of MT data to infer melt fractions are often based on presumed electrical conductivity values of partial melts. These felsic melts are believed to derive from metapelites and have peraluminous composition, but previous experimental data of electrical conductivity are only for metaluminous and peralkaline melts. In this contribution, we carry out electrical conductivity measurements on anhydrous and hydrous peraluminous granitic melts with 0.16-8.4 wt % of H 2 O at 600-1,300°C and 0.5-1.0 GPa. We find that the electrical conductivity of peraluminous melt is lower than that of peralkaline melt under dry condition, but their difference quickly diminishes at H 2 O greater than 2 wt %. Based on our experimental results, the melt fractions for various regions in the Himalaya-Tibetan crust are inferred and compared with seismological constraints.GUO ET AL. 3906

No abstract

Exosomes derived from cancer cells have been recognized as a promising biomarker for minimally invasive liquid biopsy. Herein, a novel sandwich-type biosensor was fabricated for highly sensitive detection of exosomes. Amino-functionalized Fe3O4 nanoparticles were synthesized as a sensing interface with a large surface area and rapid enrichment capacity, while two-dimensional MXene nanosheets were used as signal amplifiers with excellent electrical properties. Specifically, CD63 aptamer attached Fe3O4 nanoprobes capture the target exosomes. MXene nanosheets modified with epithelial cell adhesion molecule (EpCAM) aptamer were tethered on the electrode surface to enhance the quantification of exosomes captured with the detection of remaining protein sites. With such a design, the proposed biosensor showed a wide linear range from 102 particles μL−1 to 107 particles μL−1 for sensing 4T1 exosomes, with a low detection limit of 43 particles μL−1. In addition, this sensing platform can determine four different tumor cell types (4T1, Hela, HepG2, and A549) using surface proteins corresponding to aptamers 1 and 2 (CD63 and EpCAM) and showcases good specificity in serum samples. These preliminary results demonstrate the feasibility of establishing a sensitive, accurate, and inexpensive electrochemical sensor for detecting exosome concentrations and species. Moreover, they provide a significant reference for exosome applications in clinical settings, such as liquid biopsy and early cancer diagnosis.