The development of coalbed methane (CBM) is not only affected by geological factors, but also by engineering factors, such as artificial fracturing and drainage strategies. In order to optimize drainage strategies for wells in unique geological conditions, the characteristics of different stages of CBM production are accurately described based on the dynamic behavior of the pressure drop funnel and coal reservoir permeability. Effective depressurization is achieved by extending the pressure propagation radius and gas desorption radius to the well-controlled boundary, in the single-phase water flow stage and the gas–water flow stage, respectively, with inter-well pressure interference accomplished in the single-phase gas flow stage. A mathematic model was developed to quantitatively optimize drainage strategies for each stage, with the maximum bottom hole flow pressure (BHFP) drop rate and the maximum daily gas production calculated to guide the optimization of CBM production. Finally, six wells from the Shizhuangnan Block in the southern Qinshui Basin of China were used as a case study to verify the practical applicability of the model. Calculation results clearly indicate the differences in production characteristics as a result of different drainage strategies. Overall, if the applied drainage strategies do not achieve optimal drainage results, the coal reservoir could be irreversibly damaged, which is not conducive to expansion of the pressure drop funnel. Therefore, this optimization model provides valuable guidance for rational CBM drainage strategy development and efficient CBM production.
The main methods of coalbed methane (CBM) development are drainage and depressurization, and a precise prediction of coal reservoir pressure is thus crucial for the evaluation of reservoir potentials and the formulation of reasonable development plans. This work established a new reservoir pressure prediction model based on the material balance equation (MBE) of coal reservoir, which considers the self‐regulating effects of coal reservoirs and the dynamic change of equivalent drainage area (EDA). According to the proposed model, the reservoir pressure can be predicted based on reservoir condition data and the actual production data of a single well. Compared with traditional reservoir pressure prediction models which regard EDA as a fixed value, the proposed model can better predict the average pressure of reservoirs. Moreover, orthogonal experiments were designed to evaluate the sensitivity of reservoir parameters on the reservoir pressure prediction results of this proposed model. The results show that the saturation of irreducible water is the most sensitive parameter, followed by Langmuir volume and reservoir porosity, and Langmuir pressure is the least sensitive parameter. In addition, the pressure drop of reservoirs is negatively correlated with the saturation of irreducible water and the Langmuir volume, while it is positively correlated with porosity. This work analyzed the reservoir pressure drop characteristics of the CBM wells in the Shizhuangnan Block of the Qinshui Basin, and the results show that the CBM reservoir depressurization can be divided into three types, i.e., rapidly drop type, medium‐term stability type, and slowly drop type. The drainage features of wells were reasonably interpreted based on the comprehensive analysis of the reservoir depressurization type; the latter was coupled to the corresponding permeability dynamic change characteristics, eventually proving the applicability of the proposed model.
Due to the unique adsorption and desorption characteristics of coal, coal reservoir permeability changes dynamically during coalbed methane (CBM) development. Coal reservoirs can be classified using a permeability dynamic characterization in different production stages. In the single-phase water flow stage, four demarcating pressures are defined based on the damage from the effective stress on reservoir permeability. Coal reservoirs are classified into vulnerable, alleviative, and invulnerable reservoirs. In the gas desorption stage, two demarcating pressures are used to quantitatively characterize the recovery properties of permeability based on the recovery effect of the matrix shrinkage on permeability, namely the rebound pressure (the pressure corresponding to the lowest permeability) and recovery pressure (the pressure when permeability returns to initial permeability). Coal reservoirs are further classified into recoverable and unrecoverable reservoirs. The physical properties and influencing factors of these demarcating pressures are analyzed. Twenty-six wells from the Shizhuangnan Block in the southern Qinshui Basin of China were examined as a case study, showing that there is a significant correspondence between coal reservoir types and CBM well gas production. This study is helpful for identifying geological conditions of coal reservoirs as well as the productivity potential of CBM wells.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.