Massive multiple-input multiple-output (MIMO) is envisioned to offer considerable capacity improvement, but at the cost of high complexity of the hardware. In this paper, we propose a low-complexity hybrid precoding scheme to approach the performance of the traditional baseband zero-forcing (ZF) precoding (referred to as full-complexity ZF), which is considered a virtually optimal linear precoding scheme in massive MIMO systems. The proposed hybrid precoding scheme, named phased-ZF (PZF), essentially applies phase-only control at the RF domain and then performs a low-dimensional baseband ZF precoding based on the effective channel seen from baseband. Heavily quantized RF phase control up to $2$ bits of precision is also considered and shown to incur very limited degradation. The proposed scheme is simulated in both ideal Rayleigh fading channels and sparsely scattered millimeter wave (mmWave) channels, both achieving highly desirable performance.Comment: 10 pages, 3 figures, accepted by IEEE Wireless Communications Letter

Abstract-For a massive multiple-input multiple-output (MIMO) system, restricting the number of RF chains to far less than the number of antenna elements can significantly reduce the implementation cost compared to the full complexity RF chain configuration. In this paper, we consider the downlink communication of a massive multiuser MIMO (MU-MIMO) system and propose a low-complexity hybrid block diagonalization (Hy-BD) scheme to approach the capacity performance of the traditional BD processing method. We aim to harvest the large array gain through the phase-only RF precoding and combining and then digital BD processing is performed on the equivalent baseband channel. The proposed Hy-BD scheme is examined in both the large Rayleigh fading channels and millimeter wave (mmWave) channels. A performance analysis is further conducted for single-path channels and large number of transmit and receive antennas. Finally, simulation results demonstrate that our Hy-BD scheme, with a lower implementation and computational complexity, achieves a capacity performance that is close to (sometimes even higher than) that of the traditional high-dimensional BD processing.

This paper proposes recurrent neural networks (RNNs) for WiFi fingerprinting indoor localization. Instead of locating a mobile user's position one at a time as in the cases of conventional algorithms, our RNN solution aims at trajectory positioning and takes into account the correlation among the received signal strength indicator (RSSI) measurements in a trajectory. To enhance the accuracy among the temporal fluctuations of RSSI, a weighted average filter is proposed for both input RSSI data and sequential output locations. The results using different types of RNN including vanilla RNN, long short-term memory (LSTM), gated recurrent unit (GRU), bidirectional RNN (BiRNN), bidirectional LSTM (BiLSTM) and bidirectional GRU (BiGRU) are presented. On-site experiments demonstrate that the proposed structure achieves an average localization error of 0.75 m with 80% of the errors under one meter, which outperforms KNN algorithms and probabilistic algorithms by approximately 30% under the same test environment.Index Terms-Received signal strength indicator, WiFi indoor localization, recurrent neuron network, long short-term memory, fingerprint-based localization.

For the practical implementation of massive multiple-input multiple-output (MIMO) systems, the hybrid processing (precoding/combining) structure is promising to reduce the high cost rendered by large number of RF chains of the traditional processing structure. The hybrid processing is performed through low-dimensional digital baseband processing combined with analog RF processing enabled by phase shifters. We propose to design hybrid RF and baseband precoders/combiners for multi-stream transmission in point-to-point massive MIMO systems, by directly decomposing the pre-designed unconstrained digital precoder/combiner of a large dimension. The constant amplitude constraint of analog RF processing results in the matrix decomposition problem non-convex. Based on an alternate optimization technique, the non-convex matrix decomposition problem can be decoupled into a series of convex sub-problems and effectively solved by restricting the phase increment of each entry in the RF precoder/combiner within a small vicinity of its preceding iterate. A singular value decomposition based technique is proposed to secure an initial point sufficiently close to the global solution of the original non-convex problem. Through simulation, the convergence of the alternate optimization for such a matrix decomposition based hybrid processing (MD-HP) scheme is examined, and the performance of the MD-HP scheme is demonstrated to be near-optimal.

With the never-ending increase in the number of mobile connected devices and the need for higher data rates anywhere, anytime, higher frequency bands are being considered for communications. As millimeter-wave technology moves from research to commercial deployments, and motivated by the still limited bandwidth, the terahertz (THz) band is envisioned as the next frontier for communications. When it comes to vehicular networks, communication at much higher frequencies and, consequently, with much higher data rates brings many exciting opportunities as well as challenges. In this paper, an overview of the opportunities and challenges in THz communications for vehicular networks is provided. In addition, the papers in this Special Section which provide first-time solutions to some of these challenges, are introduced.