Computational simulation and Doehlert experimental optimization were done for the rational design of a core-shell molecularly imprinted polymer (CS-MIP) for use in the highly selective separation of Tanshinone IIA (TSIIA) from the crude extracts of Salvia miltiorrhiza Bunge (SMB). The functional monomer layer of the polymer shells directed the selective occurrence of imprinting polymerization at the surface of silica through the copolymerization of vinyl end groups with functional monomers and also drove TSIIA templates into the formed polymer shells through the charge-transfer complex interactions between TSIIA and the functional monomer layer. As a result, the maximum rebinding capacity was achieved with the use of optimal grafting ratio by the Doehlert design. The CS-MIP exhibited high recognition selectivity and binding affinity to TSIIA. When the imprinted particles were used as dispersive solid phase extraction sorbents, the recovery yield of TSIIA reached 93% by a one-step extraction from the crude extracts of SMB, and the purity of TSIIA was larger than 98% by HPLC analysis. These results show the possibility of a highly selective separation and enrichment of TSIIA from the SMB using the TSIIA-imprinted core-shell molecularly imprinted polymers.

No abstract

In this work, an AA5183 alloy plate was successfully deposited by low-power cold metal transfer technology. The forming defects, microstructural characteristics, and mechanical properties were investigated. The results show that the number of defects increases gradually along the building direction of the deposited plate. X-ray diffraction, scanning electron microscopy, energy dispersive spectroscopy, electron probe microanalysis, electron backscatter diffraction, and transmission electron microscopy were employed to study the distribution of alloying elements, deposited microstructural characteristics, and the crystal structure of intermetallic compounds in the Al alloy plate. The tensile samples perpendicular to the building direction presented greater tensile strength and superior plasticity compared to those parallel to the deposition direction. The average UTS was 327 ± 0.65 MPa and the average EL was 30.6 ± 2.0%. The UTS of conventionally forged 5083-H32 (Al-Mg4.5) alloy is 324 MPa; the UTS of extruded 5083-H116 (Al-Mg4.5) alloy is 305 MPa. Further, the strength of our prepared plate reaches the value needed for industrial applications of the 5083 Al alloy. The differences in the strength and plasticity of the samples assessed under multiple sampling methods were analyzed based on a synergistic strength–ductility mechanism.