Abstract(K,Na)NbO3 based ceramics are considered to be one of the most promising lead-free ferroelectrics replacing Pb(Zr,Ti)O3. Despite extensive studies over the last two decades, the mechanism for the enhanced piezoelectricity in multi-elements doped (K,Na)NbO3 ceramics has not been fully understood. Here, we combine temperature-dependent synchrotron x-ray diffraction and property measurements, atomic-scale scanning transmission electron microscopy, and first-principle and phase-field calculations to establish the dopant–structure–property relationship for multi-elements doped (K,Na)NbO3 ceramics. Our results indicate that the dopants induced tetragonal phase and the accompanying high-density nanoscale heterostructures with low-angle polar vectors are responsible for the high dielectric and piezoelectric properties. This work explains the mechanism of the high piezoelectricity recently achieved in (K,Na)NbO3 ceramics and provides guidance for the design of high-performance ferroelectric ceramics, which is expected to benefit numerous functional materials.

No abstract

Flexible pressure sensors have attracted a considerable amount of attention in various fields including robotics and healthcare applications, among others. However, it remains significantly challenging to design and fabricate a flexible capacitive pressure sensor with a quite broad linearity detection range due to the nonlinear stress–strain relation of the hyperelastic polymer-based dielectric material. Along these lines, in this work, a novel flexible capacitive pressure sensor with microstructured composite dielectric layer (MCDL) is demonstrated. The MCDL was prepared by enforcing a solvent-free planetary mixing and replica molding method, while the performances of the flexible capacitive pressure sensor were characterized by performing various experimental tests. More specifically, the proposed capacitive pressure sensor with 4.0 wt % cone-type MCDL could perceive external pressure loads with a broad detection range of 0–1.3 MPa, which yielded a high sensitivity value of 3.97 × 10−3 kPa−1 in a relative wide linear range of 0–600 kPa. Moreover, the developed pressure sensor exhibited excellent repeatability during the application of 1000 consecutive cycles and a fast response time of 150 ms. Finally, the developed sensor was utilized for wearable monitoring and spatial pressure distribution sensing applications, which indicates the great perspectives of our approach for potential use in the robotics and healthcare fields.

No abstract

No abstract

The rhombohedral α‐GeTe can be approximated as a slightly distorted rock‐salt structure along its [1 1 1] direction and possesses superb thermoelectric performance. However, the role of such a ferroelectric‐like structural distortion on its transport properties remains unclear. Herein, we performed a systematic study on the crystal structure and electronic band structure evolutions of Ge1‐xSnxTe alloys where the degree of ferroelectric distortion is continuously tuned. It is revealed that the band gap is maximized while multiple valence bands are converged at x = 0.6, where the ferroelectric distortion is the least but still works. Once undistorted, the band gap is considerably reduced, and the valence bands are largely separated again. Moreover, near the ferro‐to‐paraelectric phase transition Curie temperature, the lattice thermal conductivity reaches its minima because of significant lattice softening enabled by ferroelectric instability. We predict a peak ZT value of 2.6 at 673 K in α‐GeTe by use of proper dopants which are powerful in suppressing the excess hole concentrations but meanwhile exert little influence on the ferroelectric distortion.

No abstract

No abstract