No abstract

No abstract

No abstract

No abstract

Three low-carbon bainitic steels were designed to investigate the effects of Cr and Al addition on bainitic transformation, microstructures, and properties by metallographic method and dilatometry. The results show that compared with the base steel without Cr and Al addition, only Cr addition is effective for improving the strength of low-carbon bainitic steel by increasing the amount of bainite. However, compared with the base steel, combined addition of Cr and Al has no significant effect on bainitic transformation and properties. In Cr-bearing steel, Al addition accelerates initial bainitic transformation, but meanwhile reduces the final amount of bainitic transformation due to the formation of a high-temperature transformation product such as ferrite. Consequently, the composite strengthening effect of Cr and Al addition is not effective compared with individual addition of Cr in low-carbon bainitic steels. Therefore, in contrast to high-carbon steels, bainitic transformation in Cr-bearing low-carbon bainitic steels can be finished in a short time, and Al should not be added because Al addition would result in lower mechanical properties.

No abstract

Abstract:The austenite grain growth behavior in a simulated coarse-grained heat-affected zone during thermal cycling was investigated via in situ observation. Austenite grains nucleated at ferrite grain boundaries and then grew in different directions through movement of grain boundaries into the ferrite phase. Subsequently, the adjacent austenite grains impinged against each other during the α→γ transformation. After the α→γ transformation, austenite grains coarsened via the coalescence of small grains and via boundary migration between grains. The growth process of austenite grains was a continuous process during heating, isothermal holding, and cooling in simulated thermal cycling. Abundant finely dispersed nanoscale TiN particles in a steel specimen containing 0.012wt% Ti effectively retarded the grain boundary migration, which resulted in refined austenite grains. When the Ti concentration in the steel was increased, the number of TiN particles decreased and their size coarsened. The big particles were not effective in pinning the austenite grain boundary movement and resulted in coarse austenite grains.

The phase transformation from austenite to acicular ferrite in the simulated coarse grained heat affected zone of a high strength low alloy steel was investigated by means of analytical characterisation techniques such as in situ microscopy, transmission electron microscopy and electron backscattered diffraction analysis. The acicular ferrite grains nucleated on inclusions (Zr-Ti oxides) in coarse austenite grain grew in different directions and effectively partitioned coarse austenite grain into several finer and separate regions. The crystallographic grain size became small for coarse austenite grains due to the effective partitioning by acicular ferrite laths or plates.