Two-dimensional crystals are emerging materials for nanoelectronics. Development of the field requires candidate systems with both a high carrier mobility and, in contrast to graphene, a sufficiently large electronic bandgap. Here we present a detailed theoretical investigation of the atomic and electronic structure of few-layer black phosphorus (BP) to predict its electrical and optical properties. This system has a direct bandgap, tunable from 1.51 eV for a monolayer to 0.59 eV for a five-layer sample. We predict that the mobilities are hole-dominated, rather high and highly anisotropic. The monolayer is exceptional in having an extremely high hole mobility (of order 10,000 cm2 V−1 s−1) and anomalous elastic properties which reverse the anisotropy. Light absorption spectra indicate linear dichroism between perpendicular in-plane directions, which allows optical determination of the crystalline orientation and optical activation of the anisotropic transport properties. These results make few-layer BP a promising candidate for future electronics.

Because of their high theoretical energy density and low cost, lithium–sulfur (Li–S) batteries are promising next-generation energy storage devices. The electrochemical performance of Li–S batteries largely depends on the efficient reversible conversion of Li polysulfides to Li2S in discharge and to elemental S during charging. Here, we report on our discovery that monodisperse cobalt atoms embedded in nitrogen-doped graphene (Co–N/G) can trigger the surface-mediated reaction of Li polysulfides. Using a combination of operando X-ray absorption spectroscopy and first-principles calculation, we reveal that the Co–N–C coordination center serves as a bifunctional electrocatalyst to facilitate both the formation and the decomposition of Li2S in discharge and charge processes, respectively. The S@Co–N/G composite, with a high S mass ratio of 90 wt %, can deliver a gravimetric capacity of 1210 mAh g–1, and it exhibits an areal capacity of 5.1 mAh cm–2 with capacity fading rate of 0.029% per cycle over 100 cycles at 0.2 C at S loading of 6.0 mg cm–2 on the electrode disk.

Embedding continuous ultrathin-graphite foams (UGFs) with volume fractions as low as 0.8–1.2 vol% in a phase change material (PCM) can increase the effective thermal conductivity by up to 18 times, with negligible change in the melting temperature or mass specific heat of fusion.

Despite broad interest in aluminum gallium nitride (AlGaN) optoelectronic devices for deep ultraviolet (DUV) applications, the performance of conventional Al(Ga)N planar devices drastically decays when approaching the AlN end, including low internal quantum efficiencies (IQEs) and high device operation voltages. Here we show that these challenges can be addressed by utilizing nitrogen (N) polar Al(Ga)N nanowires grown directly on Si substrate. By carefully tuning the synthesis conditions, a record IQE of 80% can be realized with N-polar AlN nanowires, which is nearly ten times higher compared to high quality planar AlN. The first 210 nm emitting AlN nanowire light emitting diodes (LEDs) were achieved, with a turn on voltage of about 6 V, which is significantly lower than the commonly observed 20 – 40 V. This can be ascribed to both efficient Mg doping by controlling the nanowire growth rate and N-polarity induced internal electrical field that favors hole injection. In the end, high performance N-polar AlGaN nanowire LEDs with emission wavelengths covering the UV-B/C bands were also demonstrated.

Stacking two-dimensional (2D) materials into multi-layers or heterostructures, known as van der Waals (vdW) epitaxy, is an essential degree of freedom for tuning their properties on demand. Few-layer black phosphorus (FLBP), a material with high potential for nano-and optoelectronics applications, appears to have interlayer couplings much stronger than graphene and other 2D systems. Indeed, these couplings call into question whether the stacking of FLBP can be governed only by vdW interactions, which is of crucial importance for epitaxy and property refinement. Here, we perform a theoretical investigation of the vibrational properties of FLBP, which reflect directly its interlayer coupling, by discussing six Raman-observable phonons, including three optical, one breathing, and two shear modes. With increasing sample thickness, we find anomalous redshifts of the frequencies for each optical mode but a blueshift for the armchair shear mode. Our calculations also show splitting of the phonon branches, due to anomalous surface phenomena, and strong phonon-phonon coupling. By computing uniaxial stress effects, inter-atomic force constants, and electron densities, we provide a compelling demonstration that these properties are the consequence of strong and highly directional interlayer interactions arising from electronic hybridization of the lone electron-pairs of FLBP, rather than from vdW interactions. This exceptional interlayer coupling mechanism controls the stacking stability of BP layers and thus opens a new avenue beyond vdW epitaxy for understanding the design of 2D heterostructures.

Lithium metal is an attractive anode material for rechargeable batteries because of its high theoretical specific capacity of 3860 mA h g and the lowest negative electrochemical potential of -3.040 V versus standard hydrogen electrode. Despite extensive research efforts on tackling the safety concern raised by Li dendrites, inhibited Li dendrite growth is accompanied with decreased areal capacity and Li utilization, which are still lower than expectation for practical use. A scaffold made of covalently connected graphite microtubes is reported, which provides a firm and conductive framework with moderate specific surface area to accommodate Li metal for anodes of Li batteries. The anode presents an areal capacity of 10 mA h cm (practical gravimetric capacity of 913 mA h g ) at a current density of 10 mA cm , with Li utilization of 91%, Coulombic efficiencies of ≈97%, and long lifespan of up to 3000 h. The analysis of structure evolution during charge/discharge shows inhibited lithium dendrite growth and a reversible electrode volume change of ≈9%. It is suggested that an optimized microstructure with moderate electrode/electrolyte interface area is critical to accommodate volume change and inhibit the risks of irreversible Li consumption by side reactions and Li dendrite growth for high-performance Li-metal anodes.

No abstract

A 3D current collector made of covalently connected carbon nanostructures is presented, which can significantly improve battery performance when used as the cathode and/or anode. A Li-S cell assembled using these current collectors, with the cathode loaded with elemental sulfur and the anode loaded with lithium metal, delivers a high-rate capacity of 860 mA h g at 12 C.