No abstract

The surface properties of biomaterials play a vital role in cell morphology and behaviors such as cell adhesion, migration, proliferation and differentiation. Three different crystal phases of titania film (rutile, anatase and amorphous titania) with similar roughness were successfully synthesized by DC reactive magnetron sputtering. The surface roughness of each film was about 8-10 nm. Primary rat osteoblasts were used to observe changes in morphology and to evaluate cell behavior at the film surface. The number of the osteoblasts on anatase film was significantly higher than rutile and amorphous films after 36 and 72 h incubation. More importantly, synthesis of alkaline phosphatase was significantly greater by osteoblasts cultured on anatase film than on rutile and amorphous films after 7 and 14 days. In addition, the cells grown on the anatase phase film had the largest spreading area; the actin filaments in cells with regular directions were well defined and fully spreaded. The results indicate that the anatase phase of titania with nanoscale topography yield the best biological effects for cell adhesion, spreading, proliferation and differentiation. There are strong therapeutic prospects for this biomaterial film for osteoblast proliferation, with possible applications for orthopedic and dental implant.

No abstract

No abstract

Soy protein isolate (SPI) and wheat gluten (WG) are widely used in commercial food applications in Asia for their nutritional value and functional properties. However, individually each exhibits poor gelation. In this study, we examined the microbial transglutaminase (MTGase)-induced gelation properties of SPI and WG mixtures with high intensity ultrasonic pretreatment. Ultrasonic treatment reduced the particle size of SPI/WG molecules, which led to improvements in surface hydrophobicity (Ho) and free sulfhydryl (SH) group content. However, MTGase crosslinking facilitated the formation of disulfide bonds, markedly decreasing the content of free SH groups. Ultrasonic treatment improved the gel strength, water holding capacity, and storage modulus and resulted in denser and more homogeneous networks of MTGase-induced SPI/WG gels. In addition, ultrasonic treatment changed the secondary structure of the gel samples as determined by Fourier transform infrared spectroscopic analysis, with a reduction in α-helices and β-turns and an increase in β-sheets and random coils. Thus, ultrasound is useful in facilitating the gelation properties of MTGase-induced SPI/WG gels and might expand their utilization in the food protein gelation industry.

Atmospheric-pressure microplasma-assisted electrochemistry was used to synthesize Ag nanoparticles (NPs) for plasmonic applications. It is shown that the size and dispersion of the nanoparticles can be controlled by variation of the microplasma-assisted electrochemical process parameters such as electrolyte concentration and temperature. Moreover, Ag NP synthesis is also achieved in the absence of a stabilizer, with additional control over the dispersion and NP formation possible. As the microplasma directly reduces Ag ions in solution, the incorporation of toxic reducing agents into the electrolytic solution is unnecessary, making this an environmentally friendly fabrication technique with strong potential for the design and growth of plasmonic nanostructures for a variety of applications. These experiments therefore link microplasma-assisted electrochemical synthesis parameters with plasmonic characteristics.

Aqueous zinc ion batteries (AZIBs) are receiving increasing attention for large-scale energy storage systems owing to their appealing features with intrinsic safety, low cost, and scalability. Unfortunately, the water-induced parasitic reactions and dendrite growth on the Zn anode severely impede the further development of AZIBs. Herein, a thiourea additive is introduced into ZnSO 4 electrolyte to construct unique metal-molecule interface for simultaneously regulating the Zn anode interface chemistry and the bulk electrolyte environment. Experimental results and theoretical calculations reveal that the formed metal-molecule interface can not only serve as a corrosion inhibitor for alleviating the water-induced side reactions, but also act as a Zn 2+ ion regulator for promoting the homogenous Zn deposition, thus achieving a corrosion-free and dendrite-free Zn anode. Consequently, the Zn|Zn symmetric cell exhibits an extended lifespan of 1200 h at 1 mA cm -2 , 1mAh cm -2 , and a high cumulative capacity of 3000 mAh cm -2 at 10 mA cm -2 . When paired with V 2 O 5 cathode, the Zn|V 2 O 5 full cell delivers a high capacity retention of 76.0% after 1000 cycles at 1 A g -1 . This study paves a new way to modulate Zn electrode interface chemistry by the novel design of metal-molecule interface for advanced rechargeable Zn metal batteries and beyond.

Apart from the reported energy transfer mechanism of aggregation-induced electrochemiluminescence (AI-ECL) enhancement, a new strategy named restriction of intramolecular motions-driven ECL (RIM-ECL) enhancement is first proposed based on the phenomenon of a very strong electrochemiluminescence observed on the hexagonal tetraphenylethylene microcrystals (TPE MCs) in aqueous solution. Compared to TPE in molecule-isolation state with faint ECL, TPE in aggregate state (TPE MCs) showed a significantly enhanced ECL that was due to the restriction of intramolecular motions (RIM). Inspired by the unique luminescence characteristic of TPE MCs, we integrated the novel ECL emitter of TPE MCs and target-activated bipedal DNA walker together to fabricate a sensitive "off-on" ECL biosensor for Mucin 1 (MUC1) assay, which exhibited desirable linear response for a concentration scope from 1 fg/mL to 1 ng/mL with a low detection limit of 0.29 fg/mL. The RIM enhanced ECL demonstrated by the TPE MCs provides a new chapter in the exploration of aggregated organic emitters for further applications.