In this paper, we present a detailed analysis of the modes of a dielectric-loaded rectangular waveguide accelerating structure. In general, the acceleration field in a synchronous acceleration mode is non-uniform in the two transverse dimensions. However, we could use an array of these structures rotated alternatively by 90 degrees to get a focusing-defocusing force continuously as a simple FODO lattice, while maintaining uniform energy gain. The expressions of characteristic parameters such as R/Q, group velocity and attenuation constant are given. The longitudinal wake field experienced by a relativistic charged particle beam in the structure is also presented. These analytical results are also compared with numerical calculations using the MAFIA code suite demonstrating the validity of our analytic approach.

A decade-long effort at the Advanced Photon Source (APS) of Argonne National Laboratory (ANL) on development of superconducting undulators culminated in December 2012 with the installation of the first superconducting undulator "SCU0" into Sector 6 of the APS storage ring. The device was commissioned in January 2013 and has been in user operation since. This paper presents the magnetic and cryogenic design of the SCU0 together with the results of stand-alone cold tests. The initial commissioning and characterization of SCU0 as well as its operating experience in the APS storage ring are described.

We report on the design, numerical modeling, and experimental testing of a cylindrical dielectric loaded traveling wave structure for charged particle beam acceleration. This type of structure has similar accelerating properties to disk-loaded metal slow wave structures but with some distinct advantages in terms of simplicity of fabrication and suppression of parasitic wakefield effects. Efficient coupling of external rf power to the cylindrical dielectric waveguide is a technical challenge, particularly with structures of very high dielectric constant ⑀. We have designed and constructed an X-band structure loaded with a permittivity ⑀ϭ20 dielectric to be powered by an external rf power source. We have attained high efficiency broadband rf coupling by using a combination of a tapered dielectric end section and a carefully adjusted coupling slot. Bench testing using a network analyzer has demonstrated a power coupling efficiency in excess of 95% with bandwidth of 30 MHz, thus providing a necessary basis for construction of an accelerator using this device. We have also simulated the parameters of this structure using a finite difference time domain electromagnetic solver. Within the limits of the approximations used, the results are in reasonable agreement with the bench measurements.

Development of superconducting undulators continues at the Advanced Photon Source (APS). Two years after successful installation and commissioning of the first relatively short superconducting undulator "SCU0" in Sector 6 of the APS storage ring, the second 1.1-m-long superconducting undulator "SCU1" was installed in Sector 1 of the APS. The device has been in user operation since its commissioning in May 2015. This paper describes the magnetic and cryogenic design of the SCU1 together with the results of stand-alone cold tests. The SCU1's magnetic and cryogenic performance as well as its operating experience in the APS storage ring are also presented.

By means of the nuclear parton distribution studied only with lepton deep-inelastic scattering experimental data, the effect of spatially inhomogeneous shadowing is studied in the p-A Drell-Yan dimuon production process. Using multiple soft rescattering theory, the initial state energy loss effect is also considered within the Glauber framework. The calculated results are compared to the E772 and E866 data. It is shown that the theoretical results while considering the energy loss effect are in good agreement with the experimental data. In this paper, we also compare the calculated results of inhomogeneous shadowing with those of homogeneous and find that the inhomogeneous shadowing results exhibit a stronger energy loss effect than the homogeneous results at the same parameter.