A generalized solid-state nudged elastic band (G-SSNEB) method is presented for determining reaction pathways of solid-solid transformations involving both atomic and unit-cell degrees of freedom. We combine atomic and cell degrees of freedom into a unified description of the crystal structure so that calculated reaction paths are insensitive to the choice of periodic cell. For the rock-salt to wurtzite transition in CdSe, we demonstrate that the method is robust for mechanisms dominated either by atomic motion or by unit-cell deformation; notably, the lowest-energy transition mechanism found by our G-SSNEB changes with cell size from a concerted transformation of the cell coordinates in small cells to a nucleation event in large cells. The method is efficient and can be applied to systems in which the force and stress tensor are calculated using density functional theory.

Reaching the goal of economical photoelectrochemical (PEC) water splitting will likely require the combination of efficient solar absorbers with high activity electrocatalysts for the hydrogen and oxygen evolution reactions (HER and OER). Toward this goal, we synthesized an amorphous FeOOH (a-FeOOH) phase that has not previously been studied as an OER catalyst. The a-FeOOH films show activity comparable to that of another OER cocatalyst, Co-borate (Co-Bi), in 1 M Na2CO3, reaching 10 mA/cm(2) at an overpotential of ∼550 mV for 10 nm thick films. Additionally, the a-FeOOH thin films absorb less than 3% of the solar photons (AM1.5G) with energy greater than 1.9 eV, are homogeneous over large areas, and act as a protective layer separating the solution from the solar absorber. The utility of a-FeOOH in a realistic system is tested by depositing on amorphous Si triple junction solar cells with a photovoltaic efficiency of 6.8%. The resulting a-FeOOH/a-Si devices achieve a total water splitting efficiency of 4.3% at 0 V vs RHE in a three-electrode configuration and show no decrease in efficiency over the course of 4 h.

Transition-metal oxides are a promising class of semiconductors for the oxidation of water, a process that underpins both photoelectrochemical water splitting and carbon dioxide reduction. However, these materials are limited by very slow charge transport. This is because, unlike conventional semiconductors, material aspects of metal oxides favor the formation of slow-moving, self-trapped charge carriers: small polarons. In this Perspective, we seek to highlight the salient features of small-polaron transport in metal oxides, offer guidelines for their experimental characterization, and examine recent transport studies of two prototypical oxide photoanodes: tungsten-doped monoclinic bismuth vanadate (W:BiVO4) and titanium-doped hematite (Ti:α-Fe2O3). Analysis shows that conduction in both materials is well-described by the adiabatic small-polaron model, with electron drift mobility (distinct from the Hall mobility) values on the order of 10(-4) and 10(-2) cm(2) V(-1) s(-1), respectively. Future directions to build a full picture of charge transport in this family of materials are discussed.

Thin films of two copper-based metal vanadates (CuV2O6 and Cu2V2O7) were synthesized by a facile drop-casting method. The primary photoelectrochemical (PEC) and physical properties of these two materials including photocurrent response, band gap, flat band potential, incident photon to current conversion efficiency, chemical stability, and oxygen evolution faradaic efficiency were researched. The photocurrent density of CuV2O6 and Cu2V2O7 films at 1.23 V vs RHE in 0.1 M sodium borate buffer solution was about 25 and 35 μA/cm2, respectively. At 1.58 V vs RHE, however, the photocurrent density reached approximately 220 and 120 μA/cm2, respectively. Although the photocurrents observed for these two materials at 1.23 V vs RHE were relatively low, the photocurrents were much higher when tested with sodium sulfite as a hole scavenger. Suitable oxygen evolution catalysts are therefore expected to improve the PEC performance of these materials.