Wide–band gap metal halide perovskites are promising semiconductors to pair with silicon in tandem solar cells to pursue the goal of achieving power conversion efficiency (PCE) greater than 30% at low cost. However, wide–band gap perovskite solar cells have been fundamentally limited by photoinduced phase segregation and low open-circuit voltage. We report efficient 1.67–electron volt wide–band gap perovskite top cells using triple-halide alloys (chlorine, bromine, iodine) to tailor the band gap and stabilize the semiconductor under illumination. We show a factor of 2 increase in photocarrier lifetime and charge-carrier mobility that resulted from enhancing the solubility of chlorine by replacing some of the iodine with bromine to shrink the lattice parameter. We observed a suppression of light-induced phase segregation in films even at 100-sun illumination intensity and less than 4% degradation in semitransparent top cells after 1000 hours of maximum power point (MPP) operation at 60°C. By integrating these top cells with silicon bottom cells, we achieved a PCE of 27% in two-terminal monolithic tandems with an area of 1 square centimeter.

A new monolithic perovskite/silicon tandem solar cell architecture is proposed based on double-side-textured silicon cells with sub-micrometer pyramids. These pyramids are rough enough to scatter light within silicon nearly as efficiently as large pyramids but smooth enough to solution process a perovskite film. A bladecoated perovskite film planarizes the textured silicon cell. With a textured lightscattering layer added to the top to reduce front-surface reflectance, a monolithic perovskite/silicon tandem cell reaches an efficiency of 26%.

Synthesis of an operon fusion protein was investigated in batch and fed-batch cultures at high cell densities of recombinant Escherichia coli JM105 [pBAD-GFP::CAT]. Glucose-limited growth was achieved without accumulation of inhibitory byproducts allowing high cell densities (110 g L(-1) DCW) to be attained. This was believed to be the highest reported value for dry cell mass of E. coli strain JM105 expressing two recombinant proteins. Transcription of the two reporter genes, green fluorescent protein (GFP) and chloramphenicol acetyltransferase (CAT), was under the control of the p(BAD) promoter of the araBAD (arabinose) operon. Each protein was independently translated via separate ribosome binding sites. CAT served as a model recombinant protein product to illustrate the noninvasive quantitative reporting ability of GFP during high cell density fermentations. Expression of GFP was monitored on-line using an intensity-based optical sensor. A linear correlation between the on-line GFP intensity and the enzymatic activity of CAT allowed for in vivo real-time quantitative monitoring of a fermentation product under conditions of high biomass concentration and high productivity.

No abstract

No abstract

No abstract

No abstract

No abstract