Based on water quality surveys over 2years (July to December, in 2014 and 2015) in a typical arid river in northern China the Xingtai segment of the Fuyang River basin - the variation of nitrogen (N) and phosphorus (P) was analyzed. The extent of water eutrophication of this segment was also assessed using a universal index formula for eutrophic evaluation and a logarithmic power function. The results showed that the average concentration of total N (TN) was 27.2mg/L (NH-N, 63.5%), total P (TP) was 2.0mg/L (solution reactive phosphorus, 68.8%). Temporal and spatial variations of N and P in this segment were observed. Concentrations of N and P in the arid season were higher than those in the rainy season. Spatially, the N and P concentrations followed the same trend; i.e., higher in the city segment than in the suburbs, and decreasing along the river. The water eutrophication in the studied segment reached extremely high levels at all times (eutrophication index ≥76.3). Spatially, its trend was clearly linked with N and P. Water shortage, pollution accumulation and a weak self-purification function are the main reasons for the prominent eutrophication in this segment.

No abstract

Porous urchin‐like Co3O4 microspheres consisting of nanowires (NWs) have been obtained through a hydrothermal synthesis. This unique porous structure not only increases the number of active sites for reactions, but also provides more storage space for the discharge product Li2O2. When used as a cathode catalyst for Li−O2 batteries with nonaqueous electrolyte, the cell exhibits a much higher initial specific discharge capacity of 9013.1 mA h g−1, better rate capability and cycling stability. Furthermore, rechargeable solid‐state Li−O2 cells were prepared with a hybrid solid electrolyte (HSE) membrane composed of inorganic Li7La3Zr2O12 particles and PVDF‐HFP both as electrolyte and separator, and Co3O4‐NWs microspheres used as a catalyst for the air electrode. The solid‐state Li−O2 cell with this catalyst shows a high initial specific capacity of 8000 mA h g−1, close to that of the cell with liquid electrolyte. It also shows a better stability with low polarization.

A laboratory-built high-sensitivity flow cytometer (HSFCM) was employed for the rapid and accurate detection of lactic acid bacteria (LAB) and their viability in probiotic products. LAB were stained with both the cell membrane-permeable SYTO 9 green-fluorescent nucleic acid stain and the red-fluorescent nucleic acid stain, propidium iodide, which penetrates only bacteria with compromised membranes. The side scatter and dual-color fluorescence signals of single bacteria were detected simultaneously by the HSFCM. Ultra-high temperature processing milk and skim milk spiked with Lactobacillus casei were used as the model systems for the optimization of sample pretreatment and staining. The viable LAB counts measured by the HSFCM were in good agreement with those of the plate count method, and the measured ratios between the live and dead LAB matched well with the theoretical ratios. The established method was successfully applied to the rapid quantification of live/dead LAB in yogurts and fermented milk beverages of different brands. Moreover, the concentration and viability status of LAB in ambient yogurt, a relatively new yet popular milk product in China, are also reported.

Aquatic ecosystems in eastern China are suffering threats from heavy metal pollution because of rapid economic development and urbanization. Heavy metals in surface sediments were determined in five different aquatic ecosystems (river, reservoir, estuary, lake, and wetland ecosystems). The average Cd, Cr, Cu, Ni, Pb, and Zn concentrations were 0.716, 118, 37.3, 32.7, 56.6, and 204 mg/kg, respectively, and the higher concentrations were mainly found in sediment samples from river ecosystems. Cd was the most anthropogenically enriched pollutant, followed by Zn and Pb, indicated by enrichment factors >1.5. According to consensus-based sediment quality guidelines, potential ecological risk indices, and risk assessment codes, all five types of aquatic ecosystems were found to be polluted with heavy metals, and the most polluted ecosystems were mainly rivers. Cd was the most serious pollutant in all five aquatic ecosystems, and it was mainly found in the exchangeable fraction (about 30% of the total Cd concentration, on average). The results indicate that heavy metal contamination, especially of Cd, in aquatic ecosystems in eastern China should be taken into account in the development of management strategies for protecting the aquatic environment.

No abstract

No abstract

Fe/Al-rich river sediments that were highly polluted with phosphorus (P) were used in tests to determine the optimum preparation techniques for measuring organic P (Po) using solution 31P nuclear magnetic resonance spectroscopy (31P-NMR). The optimum pre-treatment, extraction time, sediment to solution ratio and sodium hydroxide-ethylenediaminetetraacetic acid (NaOH-EDTA) extractant solution composition were determined. The total P and Po recovery rates were higher from freeze- and air-dried samples than from fresh samples. An extraction time of 16 h was adequate for extracting Po, and a shorter or longer extraction time led to lower recoveries of total P and Po, or led to the degradation of Po. An ideal P recovery rate and good-quality NMR spectra were obtained at a sediment:solution ratio of 1∶10, showing that this ratio is ideal for extracting Po. An extractant solution of 0.25 M NaOH and 50 mM EDTA was found to be more appropriate than either NaOH on its own, or a more concentrated NaOH-EDTA mixture for 31P-NMR analysis, as this combination minimized interference from paramagnetic ions and was appropriate for the detected range of Po concentrations. The most appropriate preparation method for Po analysis, therefore, was to extract the freeze-dried and ground sediment sample with a 0.25 M NaOH and 50 mM EDTA solution at a sediment:solution ratio of 1∶10, for 16 h, by shaking. As lyophilization of the NaOH-EDTA extracts proved to be an optimal pre-concentration method for Po analysis in the river sediment, the extract was lyophilized as soon as possible, and analyzed by 31P-NMR.