No abstract

In this study, a CFD-based linear dynamics model combined with the direct Computational Fluid Dynamics/Computational Structural Dynamics (CFD/CSD) simulation method is utilized to study the physical mechanisms underlying frequency lock-in in vortex-induced vibrations (VIVs). An identification method is employed to construct the reduced-order models (ROMs) of unsteady aerodynamics for the incompressible flow past a vibrating cylinder at low Reynolds numbers (Re). Reduced-order-model-based fluid-structure interaction models for VIV are also constructed by coupling ROMs and structural motion equations. The effects of the natural frequency of the cylinder, mass ratio and structural damping coefficient on the dynamics of the coupled system at Re = 60 are investigated. The results show that the frequency lock-in phenomenon at low Reynolds numbers can be divided into two patterns according to different induced mechanisms. The two patterns are 'resonance-induced lock-in' and 'flutter-induced lock-in'. When the natural frequency of the cylinder is in the vicinity of the eigenfrequency of the uncoupled wake mode (WM), only the WM is unstable. The dynamics of the coupled system is dominated by resonance. Meanwhile, for relatively high natural frequencies (i.e. greater than the eigenfrequency of the uncoupled WM), the structure mode becomes unstable, and the coupling between the two unstable modes eventually leads to flutter. Flutter is the root cause of frequency lock-in and the higher vibration amplitude of the cylinder than that of the resonance region. This result provides evidence for the finding of De Langre (J. Fluids Struct., vol. 22, 2006, pp. 783-791) that frequency lock-in is caused by coupled-mode flutter. The linear model exactly predicts the onset reduced velocity of frequency lock-in compared with that of direct numerical simulations. In addition, the transition frequency predicted by the linear model is in close coincidence with the amplitude of the lift coefficient of a fixed cylinder for high mass ratios. Therefore, it confirms that linear models can capture a significant part of the inherent physics of the frequency lock-in phenomenon.

No abstract

No abstract

Effects of low-intensity ultrasound (at different frequency, treatment time and power) on Saccharomyces cerevisiae in different growth phase were evaluated by the biomass in the paper. In addition, the cell membrane permeability and ethanol tolerance of sonicated Saccharomyces cerevisiae were also researched. The results revealed that the biomass of Saccharomyces cerevisiae increased by 127.03% under the optimum ultrasonic conditions such as frequency 28kHz, power 140W/L and ultrasonic time 1h when Saccharomyces cerevisiae cultured to the latent anaphase. And the membrane permeability of Saccharomyces cerevisiae in latent anaphase enhanced by ultrasound, resulting in the augment of extracellular protein, nucleic acid and fructose-1,6-diphosphate (FDP) contents. In addition, sonication could accelerate the damage of high concentration alcohol to Saccharomyces cerevisiae although the ethanol tolerance of Saccharomyces cerevisiae was not affected significantly by ultrasound.

Galloping is a type of fluid-elastic instability phenomenon characterized by large-amplitude low-frequency oscillations of the structure. The aim of the present study is to reveal the underlying mechanisms of galloping of a square cylinder at low Reynolds numbers ($Re$) via linear stability analysis (LSA) and direct numerical simulations. The LSA model is constructed by coupling a reduced-order fluid model with the structure motion equation. The relevant unstable modes are first yielded by LSA, and then the development and evolution of these modes are investigated using direct numerical simulations. It is found that, for certain combinations of $Re$ and mass ratio ($m^{\ast }$), the structure mode (SM) becomes unstable beyond a critical reduced velocity $U_{c}^{\ast }$ due to the fluid–structure coupling effect. The galloping oscillation frequency matches exactly the eigenfrequency of the SM, suggesting that the instability of the SM is the primary cause of galloping phenomenon. Nevertheless, the $U_{c}^{\ast }$ predicted by LSA is significantly lower than the galloping onset $U_{g}^{\ast }$ obtained from numerical simulations. Further analysis indicates that the discrepancy is caused by the nonlinear competition between the leading fluid mode (FM) and the SM. In the pre-galloping region $U_{c}^{\ast }<U^{\ast }<U_{g}^{\ast }$, the FM quickly reaches the nonlinear saturation state and then inhibits the development of the SM, thus postponing the occurrence of galloping. When $U^{\ast }>U_{g}^{\ast }$, mode competition is weakened because of the large difference in mode frequencies, and thereby no mode lock-in can happen. Consequently, galloping occurs, with the responses determined by the joint action of SM and FM. The unstable SM leads to the low-frequency large-amplitude vibration of the cylinder, while the unstable FM results in the high-frequency vortex shedding in the wake. The dynamic mode decomposition (DMD) technique is successfully applied to extract the coherent flow structures corresponding to SM and FM, which we refer to as the galloping mode and the von Kármán mode, respectively. In addition, we show that, due to the mode competition mechanism, the galloping-type oscillation completely disappears below a critical mass ratio. From these results, we conclude that transverse galloping of a square cylinder at low $Re$ is essentially a kind of single-degree-of-freedom (SDOF) flutter, superimposed by a forced vibration induced by the natural vortex shedding. Mode competition between SM and FM in the nonlinear stage can put off the onset of galloping, and can completely suppress the galloping phenomenon at relatively low $Re$ and low $m^{\ast }$ conditions.

No abstract

Transonic buffet is a phenomenon of aerodynamic instability with shock wave motions which occurs at certain combinations of Mach number and mean angle of attack, and which limits the aircraft flight envelope. The objective of this study is to develop a modelling method for unstable flow with oscillating shock waves and moving boundaries, and to perform model-based feedback control of the two-dimensional buffet flow by means of trailing-edge flap oscillations. System identification based on the ARX algorithm is first used to derive a linear model of the input–output dynamics between the flap rotation (the control input) and the lift and pitching moment coefficients (system outputs). The model features a pair of unstable complex-conjugate poles at the characteristic buffet frequency. An appropriate reduced-order model (ROM) with a lower dimension is further obtained by a balanced truncation method that keeps the pair of unstable poles in the unstable subspace but truncates the dynamics in the stable subspace. Based on this balanced ROM, two kinds of feedback control are designed by pole assignment and linear quadratic methods respectively. These independent designs, however, result in similar suboptimal static output feedback control laws. When introduced in numerical simulations, they are both able to completely suppress the buffet instability. Furthermore, the resulting controllers are even able to stabilize buffet flows with nonlinear disturbances and in off-design flow conditions, thus implying their robustness. The analysis of the feedback control laws indicates that parameters (frequency and phase) corresponding to the ‘anti-resonance’ of the linear input–output model are vital for optimal control. The best performance is obtained when the control operates close to the ‘anti-resonance’, which is supported by the optimal frequency and the phase of the open-loop control as well as by the optimal phase of the closed-loop control.