No abstract

Typically, a special type of concrete block with cleaning holes is used in the bottom layer of traditional reinforced masonry shear walls (RMSWs) for mortar cleaning and vertical rebar connection, which results in reduced integrity and weakened structural behavior. In this paper, a precast construction technology was introduced to overcome these shortcomings. The cleaning-hole blocks were eliminated in the newly-developed precast RMSWs. Quasi-static tests on two traditional and two precast fully grouted RMSWs were conducted. The results showed that the flexural capacity of precast walls exhibited about a 10% increase when compared to traditional RMSWs under the same axial compression. Precast RMSWs that failed in flexural mode showed favorable deformation capacity and the displacement ductility value corresponding to 15% strength degradation reached 4.9. The wall stiffness degraded rapidly to 50% of the initial stiffness, K 0 , at 0.2% drift and, at 0.5% drift, the corresponding stiffness decreased to about 21% K 0 at a more gradual rate. Furthermore, precast RMSWs exhibited significant energy dissipation capacity. The experiment suggests that precast RMSWs have a satisfactory seismic performance.

The seismic performance of prefabricated reinforced concrete block masonry shear walls (PRMSWs) was studied. Five PRMSWs were tested under cyclic loading to evaluate the effect of the axial compression ratio and the distribution of the vertical rebar on the inelastic behavior. Based on the experimental results, the lateral load capacity, failure mode, lateral drift, ductility, stiffness degradation, energy dissipation, and the seismic performance stability of the specimens were analyzed. The finite element analysis of the specimens was conducted with ABAQUS, which agreed quite well with the laboratory findings. Relevant results showed that PRMSW exhibited favorable ductility and energy dissipation. The increase of the compression ratio led to stiffer, but more brittle, inelastic behavior of the specimens that had higher flexural strength. The shear walls that had concentrated vertical rebar at the sides exhibited relatively higher load capacity and less ductility compared to the walls that had evenly distributed rebar. The inelastic lateral drift limit of the PRMSW could be assigned 1/120. The equivalent viscous damping ratio of the PRMSW was 9–13% at ultimate load. These results provide a technical basis for the design and application of the PRMSW structures.