Soybean oil has been hydrogenated electrochemically in a solid polymer electrolyte (SPE) reactor at 60°C and 1 atm pressure. These experiments focused on identifying cathode designs and reactor operation conditions that improved fatty acid hydrogenation selectivities. Increasing oil mass transfer into and out of the Pd-black cathode catalyst layer (by increasing the porosity of the cathode carbon paper/cloth backing material, increasing the oil feed flow rate, and inserting a turbulence promoter into the oil feed flow channel) decreased the concentrations of stearic acid and linolenic acid in oil products [for example, an iodine value (IV) 98 oil contained 12.2% C 18:0 and 2.3% C 18:3 ]. When a second metal (Ni, Cd, Zn, Pb, Cr, Fe, Ag, Cu, or Co) was electrodeposited on a Pd-black powder cathode, substantial increases in the linolenate, linoleate, and oleate selectivities were observed. For example, a Pd/Co cathode was used to synthesize an IV 113 soybean oil with 5.3% stearic acid and 2.3% linolenic acid. The trans isomer content of soybean oil products was in the range of 6-9.5% (corresponding to specific isomerization indices of 0.15-0.40, depending on the product IV) and did not increase significantly for high fatty acid hydrogenation selectivity conditions. Paper no. J8925 in JAOCS 76, 215-222 (February 1999).
KEY WORDS:Bimetallic catalyst, electrochemical hydrogenation, fatty acid selectivity, membrane electrode assembly, Pdblack catalyst, selective hydrogenation, solid polymer electrolyte, soybean oil, specific isomerization selectivity, trans fatty acid isomers.We have reported recently on a new, low temperature and atmospheric pressure electrochemical technique for partially hydrogenating edible oils and fatty acid mixtures (1,2; Warner, K., W.E. Neff, and P. Pintauro, unpublished data). The method employed a solid polymer electrolyte (SPE) reactor, similar to that used in H 2 /O 2 fuel cells, with water as the source of hydrogen. The key component of the reactor was a "Membrane-Electrode-Assembly" (MEA), composed of RuO 2 powder (for the anode) and either Pt-black or Pdblack powder (for the cathode) that were hot-pressed as thin (fixed-bed) films onto the opposing surfaces of a Nafion cation-exchange membrane (E.I. DuPont deNemours, Inc., Wilmington, DE). During reactor operation at a constant applied current, water was back-fed to the RuO 2 anode where it was oxidized electrochemically to O 2 and H + . Protons migrated through the Nafion membrane under the influence of the applied electric field and contacted the Pt or Pd cathode where they were reduced to atomic and molecular hydrogen. The oil or fatty acid mixture was circulated past the back side of the cathode and double bonds reacted with the electrogenerated hydrogen species. A schematic diagram of the structure and reactions at an MEA during oil hydrogenation is shown in Figure 1. In our first paper (1), preliminary data were presented on SPE reactor operation during the hydrogenation of soybean, canola, and cottonseed oils and mixtures of fatty...