BackgroundIn recent years, biorefining of lignocellulosic biomass to produce multi-products such as ethanol and other biomaterials has become a dynamic research area. Pretreatment technologies that fractionate sugarcane bagasse are essential for the successful use of this feedstock in ethanol production. In this paper, we investigate modifications in the morphology and chemical composition of sugarcane bagasse submitted to a two-step treatment, using diluted acid followed by a delignification process with increasing sodium hydroxide concentrations. Detailed chemical and morphological characterization of the samples after each pretreatment condition, studied by high performance liquid chromatography, solid-state nuclear magnetic resonance, diffuse reflectance Fourier transformed infrared spectroscopy and scanning electron microscopy, is reported, together with sample crystallinity and enzymatic digestibility.ResultsChemical composition analysis performed on samples obtained after different pretreatment conditions showed that up to 96% and 85% of hemicellulose and lignin fractions, respectively, were removed by this two-step method when sodium hydroxide concentrations of 1% (m/v) or higher were used. The efficient lignin removal resulted in an enhanced hydrolysis yield reaching values around 100%. Considering the cellulose loss due to the pretreatment (maximum of 30%, depending on the process), the total cellulose conversion increases significantly from 22.0% (value for the untreated bagasse) to 72.4%. The delignification process, with consequent increase in the cellulose to lignin ratio, is also clearly observed by nuclear magnetic resonance and diffuse reflectance Fourier transformed infrared spectroscopy experiments. We also demonstrated that the morphological changes contributing to this remarkable improvement occur as a consequence of lignin removal from the sample. Bagasse unstructuring is favored by the loss of cohesion between neighboring cell walls, as well as by changes in the inner cell wall structure, such as damaging, hole formation and loss of mechanical resistance, facilitating liquid and enzyme access to crystalline cellulose.ConclusionsThe results presented herewith show the efficiency of the proposed method for improving the enzymatic digestibility of sugarcane bagasse and provide understanding of the pretreatment action mechanism. Combining the different techniques applied in this work warranted thorough information about the undergoing morphological and chemical changes and was an efficient approach to understand the morphological effects resulting from sample delignification and its influence on the enhanced hydrolysis results.

No abstract

Cytoskeletal structures are dynamically remodeled with the aid of regulatory proteins. FtsZ (filamentation temperature-sensitive Z) is the bacterial homolog of tubulin that polymerizes into rings localized to cell-division sites, and the constriction of these rings drives cytokinesis. Here we investigate the mechanism by which the Bacillus subtilis cell-division inhibitor, MciZ (mother cell inhibitor of FtsZ), blocks assembly of FtsZ. The X-ray crystal structure reveals that MciZ binds to the C-terminal polymerization interface of FtsZ, the equivalent of the minus end of tubulin. Using in vivo and in vitro assays and microscopy, we show that MciZ, at substoichiometric levels to FtsZ, causes shortening of protofilaments and blocks the assembly of higher-order FtsZ structures. The findings demonstrate an unanticipated capping-based regulatory mechanism for FtsZ.T he discovery that bacteria have actin-, tubulin-, and intermediate filament-like proteins demonstrated that the cytoskeleton is an ancient invention, predating the divergence between prokaryotes and eukaryotes (1). The GTPase FtsZ (filamentation temperature-sensitive Z) was the first prokaryotic protein to be recognized as a cytoskeletal element (2, 3). FtsZ is a tubulin-like protein, which is widely conserved in bacteria and the main component of the bacterial cytokinesis machine, or "divisome." FtsZ self-assembles into single-stranded protofilaments and these associate further inside cells to form a superstructure known as the Z ring (4, 5). FtsZ alone can generate a constriction force to initiate division (6). The Z ring also provides a scaffold onto which several other components of the divisome-mostly cell wall synthesizing enzymes-are recruited and oriented so as to build the division septum, a cross-wall separating a progenitor cell into two isogenic daughter cells (7).FtsZ and tubulin share several essential properties: their assembly is cooperative, stimulated by GTP, and leads to GTP hydrolysis; they form dynamic polymers whose turnover is dependent on nucleotide hydrolysis (8); they use essentially the same bond for polymer formation (9); and recent evidence indicates that they undergo similar allosteric transitions upon polymerization (10, 11). Not surprisingly, however, the functional specialization of these proteins led to some significant differences between them, the most prominent being that FtsZ exists as single protofilaments, whereas tubulin always adopts a multifilament tubular structure. This difference in their higherorder structure implies that the reactions that lead to cooperativity and subunit turnover are likely different. It has also represented a significant technical challenge for the study of FtsZ. Because FtsZ filaments are smaller than the resolution of optical microscopy, so far it has been impossible to determine essential properties associated with its dynamic behavior.Similarly to actin filaments and microtubules, the assembly of FtsZ protofilaments into a Z ring is regulated by a number of proteins that bind directly...

Septins form a conserved family of filament forming GTP binding proteins found in a wide range of eukaryotic cells. They share a common structural architecture consisting of an N-terminal domain, a central GTP binding domain and a C-terminal domain, which is often predicted to adopt a coiled-coil conformation, at least in part. The crystal structure of the human SEPT2/SEPT6/SEPT7 heterocomplex has revealed the importance of the GTP binding domain in filament formation, but surprisingly no electron density was observed for the C-terminal domains and their function remains obscure. The dearth of structural information concerning the C-terminal region has motivated the present study in which the putative C-terminal domains of human SEPT2, SEPT6 and SEPT7 were expressed in E. coli and purified to homogeneity. The thermal stability and secondary structure content of the domains were studied by circular dichroism spectroscopy, and homo- and hetero-interactions were investigated by size exclusion chromatography, chemical cross-linking, analytical ultracentrifugation and surface plasmon resonance. Our results show that SEPT6-C and SEPT7-C are able to form both homo- and heterodimers with a high α-helical content in solution. The heterodimer is elongated and considerably more stable than the homodimers, with a K(D) of 15.8 nM. On the other hand, the homodimer SEPT2-C has a much lower affinity, with a K(D) of 4 μM, and a moderate α-helical content. Our findings present the first direct experimental evidence toward better understanding the biophysical properties and coiled-coil pairings of such domains and their potential role in filament assembly and stability.

The septins are a conserved family of guanosine-5'-triphosphate (GTP)-binding proteins. In mammals they are involved in a variety of cellular processes, such as cytokinesis, exocytosis, and vesicle trafficking. Specifically, SEPT4 has also been shown to be expressed in both human colorectal cancer and malignant melanoma, as well as being involved in neurodegenerative disorders. However, many of the details of the modes of action of septins in general remain unclear, and little is known of their detailed molecular architecture. Here, we define explicitly and characterize the domains of human SEPT4. Regions corresponding to the N-terminal, GTPase, and C-terminal domains as well as the latter two together were successfully expressed in Escherichia coli in soluble form and purified by affinity and size-exclusion chromatographies. The purified domains were analyzed by circular dichroism spectroscopy, fluorescence spectroscopy, dynamic light scattering, and small-angle X-ray scattering, as well as with bioinformatics tools. Of the three major domains that comprise SEPT4, the N-terminal domain contains little regular secondary structure and may be intrinsically unstructured. The central GTPase domain is a mixed alpha/beta structure, probably based on an open beta sheet. As defined here, it is catalytically active and forms stable homodimers in vitro. The C-terminal domain also forms homodimers and can be divided into two regions, the second of which is alpha-helical and consistent with a coiled-coil structure. These studies should provide a useful basis for future biophysical studies of SEPT4, including the structural basis for their involvement in diseases such as cancer and neurodegenerative disorders.

Eukaryotic translation initiation factor 5A (eIF5A) is a protein that is highly conserved and essential for cell viability. This factor is the only protein known to contain the unique and essential amino acid residue hypusine. This work focused on the structural and functional characterization of Saccharomyces cerevisiae eIF5A. The tertiary structure of yeast eIF5A was modeled based on the structure of its Leishmania mexicana homologue and this model was used to predict the structural localization of new site‐directed and randomly generated mutations. Most of the 40 new mutants exhibited phenotypes that resulted from eIF‐5A protein‐folding defects. Our data provided evidence that the C‐terminal α‐helix present in yeast eIF5A is an essential structural element, whereas the eIF5A N‐terminal 10 amino acid extension not present in archaeal eIF5A homologs, is not. Moreover, the mutants containing substitutions at or in the vicinity of the hypusine modification site displayed nonviable or temperature‐sensitive phenotypes and were defective in hypusine modification. Interestingly, two of the temperature‐sensitive strains produced stable mutant eIF5A proteins – eIF5AK56A and eIF5AQ22H,L93F– and showed defects in protein synthesis at the restrictive temperature. Our data revealed important structural features of eIF5A that are required for its vital role in cell viability and underscored an essential function of eIF5A in the translation step of gene expression.

No abstract

No abstract