Hydrogenations of CO or CO2 are important catalytic reactions as they are interesting alternatives to produce fine chemical feedstock hence avoiding the use of fossil sources. Using monodisperse nanoparticle (NP) catalysts, we have studied the CO/H2 (i.e., Fischer-Tropsch synthesis) and CO2/H2 reactions. Exploiting synchrotron based in situ characterization techniques such as XANES and XPS, we were able to demonstrate that 10 nm Co NPs cannot be reduced at 250 °C while supported on TiO2 or SiO2 and that the complete reduction of cobalt can only be achieved at 450 °C. Interestingly, cobalt oxide performs better than fully reduced cobalt when supported on TiO2. In fact, the catalytic results indicate an enhancement of 10-fold for the CO2/H2 reaction rate and 2-fold for the CO/H2 reaction rate for the Co/TiO2 treated at 250 °C in H2 versus Co/TiO2 treated at 450 °C. Inversely, the activity of cobalt supported on SiO2 has a higher turnover frequency when cobalt is metallic. The product distributions could be tuned depending on the support and the oxidation state of cobalt. For oxidized cobalt on TiO2, we observed an increase of methane production for the CO2/H2 reaction whereas it is more selective to unsaturated products for the CO/H2 reaction. In situ investigation of the catalysts indicated wetting of the TiO2 support by CoO(x) and partial encapsulation of metallic Co by TiO(2-x).

Carbon dioxide capture and use as a carbon feedstock presents both environmental and industrial benefits. Here we report the discovery of a hybrid oxide catalyst comprising manganese oxide nanoparticles supported on mesoporous spinel cobalt oxide, which catalyses the conversion of carbon dioxide to methanol at high yields. In addition, carbon-carbon bond formation is observed through the production of ethylene. We document the existence of an active interface between cobalt oxide surface layers and manganese oxide nanoparticles by using X-ray absorption spectroscopy and electron energy-loss spectroscopy in the scanning transmission electron microscopy mode. Through control experiments, we find that the catalyst's chemical nature and architecture are the key factors in enabling the enhanced methanol synthesis and ethylene production. To demonstrate the industrial applicability, the catalyst is also run under high conversion regimes, showing its potential as a substitute for current methanol synthesis technologies.

Nanoparticles (Pd, Pt, Rh) stabilized by G4OH PAMAM dendrimers and supported in SBA-15 (MNPs/SBA-15 with M = Pd, Pt, Rh) were efficiently used as catalysts in the acceptorless dehydrogenation of tetrahydroquinoline/indoline derivatives in toluene (release of H) at 130 °C. These catalysts are air stable, very active, robust, and recyclable during the process. The reverse hydrogenation reaction of quinoline derivatives (H storage) was also optimized and successfully performed in the presence of the same catalysts in toluene at 60 °C under only 1 atm of hydrogen gas. Such catalysts may be essential for the adoption of organic hydrogen-storage materials as an alternative to petroleum-derived fuels. Hot filtration test confirmed that the reaction follows a heterogeneous pathway. Moreover, PdNPs/SBA-15 was an excellent catalyst for the direct arylation at the C-2 position (via C-H activation) of indole in water in the presense of a hypervalent iodine oxidant. Thus, a one-pot dehydrogenation/direct arylation cascade reaction between indoline and an arylated agent was efficaciously performed in water, demonstrating the potential of the system to catalyze tandem heterogeneous/homogeneous processes by choice of the appropriate oxidant/reductant.

Fluorinated compounds are added to carbonate-based electrolyte solutions in an effort to create a stable solid electrolyte interphase (SEI). The SEI mitigates detrimental electrolyte redox reactions taking place on the anode's surface upon applying a potential in order to charge (discharge) the lithium (Li) ion battery. The need for a stable SEI is dire when the anode material is silicon as silicon cracks due to its expansion and contraction upon lithiation and delithiation (charge-discharge) cycles, consequently limiting the cyclability of a silicon-based battery. Here we show the molecular structures for ethylene carbonate (EC): fluoroethylene carbonate (FEC) solutions on silicon surfaces by sum frequency generation (SFG) vibrational spectroscopy, which yields vibrational spectra of molecules at interfaces and by ab initio molecular dynamics (AIMD) simulations at open circuit potential. Our AIMD simulations and SFG spectra indicate that both EC and FEC adsorb to the amorphous silicon (a-Si) through their carbonyl group (C═O) oxygen atom with no further desorption. We show that FEC additives induce the reorientation of EC molecules to create an ordered, up-right orientation of the electrolytes on the Si surface. We suggest that this might be helpful for Li diffusion under applied potential. Furthermore, FEC becomes the dominant species at the a-Si surface as the FEC concentration increases above 20 wt %. Our finding at open circuit potential can now initiate additive design to not only act as a sacrificial compound but also to produce a better suited SEI for the use of silicon anodes in the Li-ion vehicular industry.

The hydrogenation of crotonaldehyde by platinum nanoparticles supported on cobalt oxide was used as a reaction to probe the effect of the interface between the two materials on the activity and selectivity of the catalyst. Four potential products can be formed by this reaction: propylene, butyraldehyde, crotyl alcohol, and butanol. When Pt nanoparticles are supported on SiO 2 , an inert support, only propylene and butyraldehyde are formed. However, when Pt is supported on cobalt oxide, the alcohols make up roughly 40% of the total activity, indicating that cobalt oxide plays a pivotal role in the reaction, much like other active supports such as TiO 2 . To elucidate the mechanism of alcohol formation, in situ sum frequency generation vibrational spectroscopy (SFG) and ambient-pressure X-ray photoelectron spectroscopy (AP-XPS) were utilized to probe the reactant adsorption and intermediate formation and the chemical state of the materials under working catalytic conditions. The SFG data indicate that crotonaldehyde adsorbs on the oxide surface, likely through the aldehyde oxygen as well as on the Pt surface through the alkene group. AP-XPS results show that the surface of the Co 3 O 4 support becomes partially reduced under the reaction conditions and Pt exists in its metallic state. Taking these results together, we propose that the crotonaldehyde adsorbs at reduced oxide surface sites and that this adsorption mode is responsible for the production of alcohol products. A platinum nanoparticle density dependence study was also undertaken to change the abundance of interface sites and study their effect on the reaction. The selectivity between the two alcohol products was altered as a function of the Pt nanoparticle density: higher selectivity toward butanol and lower selectivity toward crotyl alcohol was obtained with increasing density, while propylene and butyraldehyde selectivities were constant with respect to density. On the basis of the data presented, we propose that butanol is preferentially formed at the metal−oxide interface, while crotyl alcohol is formed at oxide surface sites by reaction with spillover hydrogen.

Pt, Rh, and Pd nanoclusters stabilized by PAMAM dendrimer are used for the first time in a gas flow reactor at high temperature (150-250 °C). Pt nanoclusters show a very high activity for the hydrogenation of the methylcyclopentane (MCP) at 200-225 °C with turnover freqency (TOF) up to 334 h and selectivity up to 99.6% for the ring opening isomerization at very high conversion (94%). Rh nanoclusters show different selectivity for the reaction, that is, ring opening isomerization at 175 °C and cracking at higher temperature whereas Pd nanoclusters perform ring enlargement plus dehydrogenation, while maintaining a high activity. The difference in these results as compared to unsupported/uncapped nanoparticles, demonstrates the crucial role of dendrimer. The tunability of the selectivity of the reaction as well as the very high activity of the metal nanoclusters stabilized by dendrimer under heterogeneous conditions open a new application for dendrimer catalysts.

The Fischer-Tropsch process, or the catalytic hydrogenation of carbon monoxide (CO), produces long chain hydrocarbons and offers an alternative to the use of crude oil for chemical feedstocks. The observed size dependence of cobalt (Co) catalysts for the Fischer-Tropsch reaction was studied with colloidally prepared Co nanoparticles and a chemical transient kinetics reactor capable of measurements under non-steady-state conditions. Co nanoparticles of 4.3 nm and 9.5 nm diameters were synthesized and tested under atmospheric pressure conditions and H /CO=2. Large differences in carbon coverage (Θ ) were observed for the two catalysts: the 4.3 nm Co catalyst has a Θ less than one while the 9.5 nm Co catalyst supports a Θ greater than two. The monomer units present on the surface during reaction are identified as single carbon species for both sizes of Co nanoparticles, and the major CO dissociation site is identified as the B -B geometry. The difference in activity of Co nanoparticles was found to be a result of the structure sensitivity caused by the loss of these specific types of sites at smaller nanoparticle sizes.

Understanding the C-C bond activation mechanism is essential for developing the selective production of hydrocarbons in the petroleum industry and for selective polymer decomposition. In this work, ring-opening reactions of cyclopropane derivatives under hydrogen catalyzed by metal nanoparticles (NPs) in the liquid phase were studied. 40-atom rhodium (Rh) NPs, encapsulated by dendrimer molecules and supported in mesoporous silica, catalyzed the ring opening of cyclopropylbenzene at room temperature under hydrogen in benzene, and the turnover frequency (TOF) was higher than other metals or the Rh homogeneous catalyst counterparts. Comparison of reactants with various substitution groups showed that electron donation on the three-membered ring boosted the TOF of ring opening. The linear products formed with 100% selectivity for ring opening of all reactants catalyzed by the Rh NP. Surface Rh(0) acted as the active site in the NP. The capping agent played an important role in the ring-opening reaction kinetics. Larger particle size tended to show higher TOF and smaller reaction activation energy for Rh NPs encapsulated in either dendrimer or poly(vinylpyrrolidone). The generation/size of dendrimer and surface group also affected the reaction rate and activation energy.