[1] We used airborne altimetry measurements to determine the volume changes of 23 glaciers in the western Chugach Mountains, Alaska, United States, between 1950/1957. Average net balance rates ranged between À3.1 to 0.16 m yr À1 for the tidewater and À1.5 to À0.02 m yr À1 for the nontidewater glaciers. We tested several methods for extrapolating these measurements to all the glaciers of the western Chugach Mountains using a process similar to cross validation. Predictions of individual glacier changes appear to be difficult, probably because of the effects of glacier dynamics, which on long (multidecadal) timescales, complicates the response of glaciers to climate. In contrast, estimates of regional contributions to rising sea level were similar for different methods, mainly because the large glaciers, whose changes dominated the regional total, were among those measured. For instance, the above sea level net balance rate of Columbia glacier (À3.1 ± 0.08 km 3 yr À1 water equivalent (weq) or an equivalent rise in sea level (SLE) of 0.0090 ± 0.0002 mm yr
ABSTRACT. A transverse profile of velocity was measured across Ice Stream B, West Antarctica, in order to determine the role of the margins in the force balance of an active ice stream. The profile extended from near the ice-stream center line, through a marginal shear zone and on to the slow-moving ice sheet. The velocity profile exhibits a high degree of shear d eformation within a marginal zone, where intense, chaotic crevassing occurs. Detailed analysis of the profile, using analytical and numerical models of ice flow, leads to the following conclusions regarding the roles of the bed and the margins in ice-stre a m dynamics: While the exact quantitative values leading to these conclusions are somewhat model and location-dependent, th e overall conclusions are robust. As such, they are likely to have importa nce for ice-strea m dynamics in gen eral.
Bore-hole photography demonstrates that the glacier bed was reached by cable-tool drilling in five bore holes in Blue Glacier, Washington. Basal sliding velocities measured by bore-hole photography, and confirmed by inclinometry, range from 0.3 to 3.0 cm/d and average 1.0 cm/d, much less than half the surface velocity of 15 cm/d. Sliding directions deviate up to 30° from the surface flow direction. Marked lateral and time variations in sliding velocity occur. The glacier bed consists of bedrock overlain by a ≈ 10 cm layer of active subsole drift, which intervenes between bedrock and ice sole and is actively involved in the sliding process. It forms a mechanically and visibly distinct layer, partially to completely ice-free, beneath the zone of debris-laden ice at the base of the glacier. Internal motions in the subsole drift include rolling of clasts caught between bedrock and moving ice. The largest sliding velocities occur in places where a basal gap, of width up to a few centimeters, intervenes between ice sole and subsole drift. The gap may result from ice—bed separation due to pressurization of the bed by bore-hole water. Water levels in bore holes reaching the bed drop to the bottom when good hydraulic connection is established with sub-glacial conduits; the water pressure in the conduits is essentially atmospheric. Factors responsible for the generally low sliding velocities are high bed roughness due to subsole drift, partial support of basal shear stress by rock friction, and minimal basal cavitation because of low water pressure in subglacial conduits. The observed basal conditions do not closely correspond to those assumed in existing theories of sliding.
Microscopic and textural observations were made on ice samples cored from Blue Glacier slightly below the equilibrium line to depths of 60 m. Observations were started within a few minutes after collection. Water was found in veins along three-grain intersections, in lenses on grain boundaries and in irregular shapes. Gas was found in bubbles in the interior of crystals, in bubbles touching veins, and locally in veins. Vein sizes showed some spread; average cross-sectional area was about 7 × 10−4 mm2 with no discernible, trend with texture or depth except within 7 m of the surface. Before the samples were examined they could have experienced a complex relaxation which could have changed them significantly. As a result it is not possible to determine the in situ size of veins, but an upper limit can be determined. Also it is not possible to predict intergranular water flux per unit area, but 1 × 10−1 m a−1 represents an upper limit. In coarse-grained ice the water flux density is likely to be even smaller, because of a low density of veins, and blocking by bubbles. This indicates that only a very small fraction of the melt-water production on a typical summer day can penetrate into the glacier on an intergranular scale except possibly near the surface. The existence of conduit-like features in several cores suggests that much melt water can nevertheless penetrate the ice locally without large-scale lateral movements along the glacier surface. The observed profile of ice temperature indicates that the intergranular water flux may be much smaller than the upper limit determined from the core samples.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.