We propose a satellite-based scheme to perform clock synchronization between ground stations spread across the globe using quantum resources. We refer to this as a quantum clock synchronization (QCS) network. Through detailed numerical simulations, we assess the feasibility and capabilities of a near-term implementation of this scheme. We consider a small constellation of satellites equipped only with modest resources. These include quantum devices such as spontaneous parametric down conversion (SPDC) sources, avalanche photo-detectors (APDs), and moderately stable on-board clocks such as chip scale atomic clocks (CSACs). In our simulations, the various performance parameters describing the hardware have been chosen such that they are either already commercially available, or require only moderate advances. We conclude that with such a scheme establishing a global network of ground based clocks synchronized to sub-nanosecond level (up to a few picoseconds) of precision, would be feasible. Such QCS satellite constellations would form the infrastructure for a future quantum network, able to serve as a globally accessible entanglement resource. At the same time, our clock synchronization protocol, provides the sub-nanosecond level synchronization required for many quantum networking protocols, and thus, can be seen as adding an extra layer of utility to quantum technologies in the space domain designed for other purposes.

No abstract

No abstract

Micro-electro-mechanical systems (MEMS) switches for radio-frequency (RF) signals have certain advantages over solid-state switches, such as lower insertion loss, higher isolation, and lower static power dissipation. Mechanical dynamics can be a determining factor for the reliability of RF MEMS. The RF MEMS ohmic switch discussed in this paper consists of a plate suspended over an actuation pad by four double-cantilever springs. Closing the switch with a simple step actuation voltage typically causes the plate to rebound from its electrical contacts. The rebound interrupts the signal continuity and degrades the performance, reliability and durability of the switch. The switching dynamics are complicated by a nonlinear, electrostatic pull-in instability that causes high accelerations. Slow actuation and tailored voltage control signals can mitigate switch bouncing and effects of the pull-in instability; however, slow switching speed and overly-complex input signals can significantly penalize overall system-level performance. Examination of a balanced and optimized alternative switching solution is sought. A step toward one solution is to consider a pull-in-free switch design. In this paper, determine how simple RC-circuit drive signals and particular structural properties influence the mechanical dynamics of an RF MEMS switch designed without a pull-in instability. The approach is to develop a validated modeling capability and subsequently study switch behavior for variable drive signals and switch design parameters.In support of project development, specifiable design parameters and constraints will be provided. Moreover, transient data of RF MEMS switches from laser Doppler velocimetry will be provided for model validation tasks. Analysis showed that a RF MEMS switch could feasibly be designed with a single pulse waveform and no pull-in instability and achieve comparable results to previous waveform designs. The switch design could reliably close in a timely manner, with small contact velocity, usually with little to no rebound even when considering manufacturing variability.

No abstract

No abstract

No abstract

Methods developed at the Texas Advanced Computing Center (TACC) are described and demonstrated for automating the construction of an elastic, virtual cluster emulating the Stampede2 high performance computing (HPC) system. The cluster can be built and/or scaled in a matter of minutes on the Jetstream self-service cloud system and shares many properties of the original Stampede2, including: i) common identity management, ii) access to the same file systems, iii) equivalent software application stack and module system, iv) similar job scheduling interface via Slurm.We measure time-to-solution for a number of common scientific applications on our virtual cluster against equivalent runs on Stampede2 and develop an application profile where performance is similar or otherwise acceptable. For such applications, the virtual cluster provides an effective form of "cloud bursting" with the potential to significantly improve overall turnaround time, particularly when Stampede2 is experiencing long queue wait times. In addition, the virtual cluster can be used for test and debug without directly impacting Stampede2. We conclude with a discussion of how science gateways can leverage the TACC Jobs API web service to incorporate this cloud bursting technique transparently to the end user.