Two p-cymenerutheniumchlorido complexes with thiourea derivative of 7-chloroquinoline (C1) and pyridine-3-imidazole (C2) were synthesized starting from [(η 6 -p-cymene)RuCl 2 ] 2 and corresponding ligands. The structures of complexes were determined with elemental analysis and IR, ESIMS, 1 H and 13 C{ 1 H} NMR, and 2D 1 H− 15 N correlation NMR spectroscopy. Cytotoxic activities examined by the MTT assay were performed in five human neoplastic cell lines (HeLa, K562, A549, MDA-MB-231, EA.hy926) and one nontumor human fetal lung fibroblast cell line (MRC-5). Tested complexes exhibited low micromolar activities with IC 50 in the range 11.03−56.45 μM, while ligands L1 and L2 were significantly less active. Complex C1 showed cytoselective activity toward the K562 cell line (IC 50 = 11.03 ± 1.39 μM) and was 3 times less active against the nontumor MRC-5 cell line. Flow cytometry analysis indicated that complexes C1 and C2 after 24 h treatment caused a concentration-dependent increase of the apoptotic sub-G1 fraction (up to 18.4%), comparable to cis-diamminedichloridoplatinum(II) (cisplatin, CDDP), although without other substantial alterations of the cell cycle. A drug-accumulation and DNA-binding study performed by ICP-MS in the K562 cell line revealed that complex C1 had a high intracellular uptake (1.38 μg Ru/10 6 cells), which significantly exceeded the intracellular uptake levels of CDDP (0.29 μg Pt/10 6 cells) and C2 (0.08 μg Ru/10 6 cells). However, both ruthenium complexes C1 and C2 bind to cellular DNA less efficiently in comparison to CDDP. The structure−activity relationship clearly suggested that introduction of a 7-chloroquinoline moiety in the ruthenium(II)-p-cymene complex significantly contributed to the intracellular uptake of C1 and higher cytotoxicity and cytoselectivity.
Botulinum neurotoxins (BoNTs), composed of a family of seven serotypes (categorized A – G), are the deadliest of known biological toxins. The activity of the metalloprotease, light chain (LC) component of the toxins is responsible for causing the life-threatening paralysis associated with the disease botulism. Herein we report significantly more potent analogs of novel, lead BoNT serotype A LC inhibitor 2,5-bis(4-amidinophenyl)thiophene (Ki = 10.88 μM ± 0.90 μM). Specifically, synthetic modifications involved simultaneously replacing the lead inhibitor’s terminal bis-amidines with secondary amines and the systematic tethering of 4-amino-7-chloroquinoline substituents to provide derivatives with Ki values ranging from 0.302 μM (± 0.03 μM) – 0.889 μM (± 0.11 μM).
The design and evaluation of novel 2-hydroxyethyl methacrylate/gelatin/alginate/graphene oxide hydrogels as innovative scaffolding biomaterials, which concurrently are the suitable drug delivery carrier, was proposed. The hydrogels were prepared by the adapted porogen leaching method; this is also the first time this method has been used to incorporate nanocolloidal graphene oxide through the hydrogel and simultaneously form porous structures. The effects of a material’s composition on its chemical, morphological, mechanical, and swelling properties, as well as on cell viability and in vitro degradation, were assessed using Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), measurements of Young’s modulus, gravimeter method and MTT test, respectively. The engineered hydrogels show good swelling capacity, fully hydrophilic surfaces, tunable porosity (from 56 to 76%) and mechanical properties (from 1.69 to 4.78 MPa), curcumin entrapment efficiency above 99% and excellent curcumin release performances. In vitro cytotoxicity on healthy human fibroblast (MRC5 cells) by MTT test reveal that the materials are nontoxic and biocompatible, proposing novel hydrogels for in vivo clinical evaluation to optimize tissue regeneration treatments by coupling the hydrogels with cells and different active agents to create material/biofactor hybrids with new levels of biofunctionality.
Scaffold hydrogel biomaterials designed to have advantageous biofunctional properties, which can be applied for controlled bioactive agent release, represent an important concept in biomedical tissue engineering. Our goal was to create scaffolding materials that mimic living tissue for biomedical utilization. In this study, two novel series of interpenetrating hydrogel networks (IPNs) based on 2-hydroxyethyl methacrylate/gelatin and 2-hydroxyethyl methacrylate/alginate were crosslinked using N-ethyl-N′-(3-dimethyl aminopropyl)carbodiimide hydrochloride (EDC) and N-hydroxysuccinimide (NHS). Characterization included examining the effects of crosslinker type and concentration on structure, morphological and mechanical properties, in vitro swelling, hydrophilicity as well as on the in vitro cell viability (fibroblast cells) and in vivo (Caenorhabditis elegans) interactions of novel biomaterials. The engineered IPN hydrogel scaffolds show an interconnected pore morphology and porosity range of 62.36 to 85.20%, favorable in vitro swelling capacity, full hydrophilicity, and Young’s modulus values in the range of 1.40 to 7.50 MPa. In vitro assay on healthy human fibroblast (MRC5 cells) by MTT test and in vivo (Caenorhabditis elegans) survival assays show the advantageous biocompatible properties of novel IPN hydrogel scaffolds. Furthermore, in vitro controlled release study of the therapeutic agent resveratrol showed that these novel scaffolding systems are suitable controlled release platforms. The results revealed that the use of EDC and the combination of EDC/NHS crosslinkers can be applied to prepare and tune the properties of the IPN 2-hydroxyethyl methacrylate/alginate and 2-hydroxyethyl methacrylate/gelatin hydrogel scaffolds series, which have shown great potential for biomedical engineering applications.
New composite 3D scaffolds were developed as a combination of synthetic polymer, poly(2-hydroxyethyl methacrylate) (PHEMA), and a natural polymer, gelatin, with a ceramic component, nanohydroxyapatite (ID nHAp) dopped with metal ions. The combination of a synthetic polymer, to be able to tune the structure and the physicochemical and mechanical properties, and a natural polymer, to ensure the specific biological functions of the scaffold, with inorganic filler was applied. The goal was to make a new material with superior properties for applications in the biomedical field which mimics as closely as possible the native bone extracellular matrix (ECM). Biodegradable PHEMA hydrogel was obtained by crosslinking HEMA by poly(β-amino esters) (PBAE). The scaffold’s physicochemical and mechanical properties, in vitro degradation, and biological activity were assessed so to study the effects of the incorporation of nHAp in the (PHEMA/PBAE/gelatin) hydrogel, as well as the effect of the different pore-forming methods. Cryogels had higher elasticity, swelling, porosity, and percent of mass loss during degradation than the samples obtained by porogenation. The composite scaffolds had a higher mechanical strength, 10.14 MPa for the porogenated samples and 5.87 MPa for the cryogels, but a slightly lower degree of swelling, percent of mass loss, and porosity than the hybrid ones. All the scaffolds were nontoxic and had a high cell adhesion rate, which was 15–20% higher in the composite samples. Cell metabolic activity after 2 and 7 days of culture was higher in the composites, although not statistically different. After 28 days, cell metabolic activity was similar in all scaffolds and the TCP control. No effect of integrating nHAp into the scaffolds on osteogenic cell differentiation could be observed. Synergetic effects occurred which influenced the mechanical behavior, structure, physicochemical properties, and interactions with biological species.
Our goal was to create bioimitated scaffolding materials for biomedical purposes. The guiding idea was that we used an interpenetrating structural hierarchy of natural extracellular matrix as a “pattern” to design hydrogel scaffolds that show favorable properties for tissue regeneration. Polymeric hydrogel scaffolds are made in a simple, environmentally friendly way without additional functionalization. Gelatin and 2-hydroxyethyl methacrylate were selected to prepare interpenetrating polymeric networks and linear alginate chains were added as an interpenetrant to study their influence on the scaffold’s functionalities. Cryogelation and porogenation methods were used to obtain the designed scaffolding biomaterials. The scaffold’s structural, morphological, and mechanical properties, in vitro degradation, and cell viability properties were assessed to study the effects of the preparation method and alginate loading. Apatite as an inorganic agent was incorporated into cryogelated scaffolds to perform an extensive biological assay. Cryogelated scaffolds possess superior functionalities essential for tissue regeneration: fully hydrophilicity, degradability and mechanical features (2.08–9.75 MPa), and an optimal LDH activity. Furthermore, cryogelated scaffolds loaded with apatite showed good cell adhesion capacity, biocompatibility, and non-toxic behavior. All scaffolds performed equally in terms of metabolic activity and osteoconductivity. Cryogelated scaffolds with/without HAp could represent a new advance to promote osteoconductivity and enhance hard tissue repair. The obtained series of scaffolding biomaterials described here can provide a wide range of potential applications in the area of biomedical engineering.
New (β‐aminoester) hydrogels (PBAE) based on di(ethylene glycol)diacrylate and glycine are successfully synthesized and characterized for the first time in this work. PBAE macromers are obtained using Michael addition. By changing the diacrylate/amine stoichiometric ratio, but maintaining it >1, samples with different chemical structure containing acrylate end‐groups are obtained. The hydrogels are synthesized from macromers utilizing free radical polymerization. Chemical structure of macromers and hydrogels is confirmed by proton nuclear magnetic resonance, and Fourier transform infra‐red spectroscopy. Swelling and degradation rates in physiological pH range change notably with pH and monomer molar ratio, validating pH sensitivity and zwitterionic behavior, which can be finely tuned by changing any of these parameters. In vitro cytotoxicity and in vivo acute embryotoxicity in zebrafish (Danio rerio) performed to assess the biocompatibility of the novel hydrogel materials and their degradation products reveal that materials are nontoxic and biocompatible. The Cephalexin in vitro drug release study, at pH values 2.20, 5.50, and 7.40, demonstrates pH‐sensitive delivery with the release profiles effectively controlled by pH and the hydrogel composition. PBAE hydrogels exhibit great potential for a variety of biomedical applications, including tissue regeneration and intelligent drug delivery systems.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
334 Leonard St
Brooklyn, NY 11211
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.