Mechanical fracture properties of interfacial transition zone (ITZ) of fine-grained composite based on cement matrix with different types – basalt, granite, marble and amphibolite – of rock inclusion were studied. Specimens with the initial stress concentrator were tested in standard three-point bending configuration. Fracture surfaces were examined with light and electron microscopes. Local ITZ response was characterized by nanoindentation in the vicinity of rock inclusions. Local elasticity, hardness and viscous properties were assessed. It has been shown that the ITZ is mechanically weaker compared to the bulk matrix in the region of ca. 0–20 μm from the inclusion for all specimen’s types. It exhibits gradual increase of elastic modulus and hardness, which can be approximately expressed by a power law. On the other hand, the creep in ITZ was found to be higher compared to the bulk matrix. The results of nanoindentation measurements are in a good agreement with overall mechanical properties, fracture response and microstructure measurements done by scanning electron microscopy.
This contribution deals with the efficiency of electromigration of chlorides used as a repair method for reinforced concrete structures. Experimental studies of accelerated chloride transport tests were performed on samples of concrete without chlorides and with admixed sodium chloride during concreting. Two concrete types from Portland cement characterized with normal and low compressive strengths were studied. The electromigration was applied to penetrate chlorides into the chloride-free sample and for extraction of chlorides from the sample. The effectiveness of the chloride extraction process for rehabilitation of reinforced concrete in terms of lowering the chloride concentration in different concrete types and surface concentration was observed. Electrical extraction was found to be effective for lowering of initial chloride concentration by 15-20% after 24 hours. The decrease in surface concentrations was found in the range of 40-50%. The extraction process was found to be feasible and effective for both concrete types.
This paper shows a micromechanical study of interfacial transition zone (ITZ) around steel fiber in cement paste. It investigates microstructure and mechanical performance of the ITZ by a combination of nanoindentation and scanning electron microscopy (SEM). The investigated specimens were made from cement CEM I 42.5R paste with dispersed reinforcement in the form of steel fiber TriTreg 50 mm. The SEM demonstrated larger porosity and smaller portion of clinkers in the ITZ. Nanoindentation delivered values of elastic modulus, hardness and creep parameters around the fiber. An average value of elastic modulus in ITZ was at the level of 67% in comparison with cement bulk and the width of ITZ was about 40 µm. The value of hardness was found to be 60% of the average hardness of the bulk cement paste. The measured load-displacement curves were used for calculation of creep indentation parameter (CIT) and the creep compliance function. An average value of the creep compliance in the ITZ was found to be two times higher than in the cement bulk.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.