No abstract

No abstract

The paper presents a study concerning the role of ferroelectric filler size and clustering in the dielectric properties of 20%BaTiO 3 −80%PVDF and of 20% (2%Ag−98%BaTiO 3 )−PVDF hybrid nanocomposites. By finite element calculations, it was shown that using fillers with ε > 10 3 does not provide a permittivity rise in the composites and the effective dielectric constant tends to saturate to specific values determined by the filler size and agglomeration degree. Irrespective of the ferroelectric filler sizes, the addition of metallic ultrafine nanoparticles (Ag) results in permittivity intensification and the effect is even stronger if the metallic nanoparticles are connected to a higher degree with the ferroelectric particles' surfaces. When using coarse ferroelectric fillers, the probability of clustering is higher, thus favoring the permittivity increase by field concentration in small regions close to the interfaces separating dissimilar materials. The modeling results were validated by an experimental dielectric analysis performed in a series of PVDF-based thick films with the same amount of BaTiO 3 fillers or with Ag−BaTiO 3 hybrid fillers. Similar trends as predicted by simulations were found experimentally but with slightly higher permittivity values which were assigned to the modifications of the polymer phase composition due to the presence of nanofillers and the local sample inhomogeneity (the presence of clustering, in particular for coarse BaTiO 3 grains), which create regions with enhanced local fields.

The present paper reports the dependence of dielectric, ferroelectric and piezoelectric properties on the porosity level in BaZr0.15Ti0.85O3 ceramics with porosity from 5% to 21%. Microporosity with 0–3 connectivity has been produced using PMMA microspheres as a sacrificial template. The functional properties (dielectric, ferroelectric and piezoelectric effect) are mostly affected by the “dilution effect”: permittivity decreases by 40% when porosity increases by 21%, and Pmax decreases from 13 to 5 µC/cm2 while the Prem is in the range of (2–8) µC/cm2. However, the reduction of the zero-field permittivity and hysteretic behaviour of ε(E) while the tunability level is still high makes from porous ceramics interesting materials for tunability application.

No abstract

No abstract

No abstract

No abstract