A trifunctional, partially fluorinated anthracene-substituted triptycene monomer was spread at an air/water interface into a monolayer, which was transformed into a long-range-ordered 2D polymer by irradiation with a standard UV lamp. The polymer was analyzed by Brewster angle microscopy, scanning tunneling microscopy measurements, and non-contact atomic force microscopy, which confirmed the generation of a network structure with lattice parameters that are virtually identical to a structural model network based on X-ray diffractometry of a closely related 2D polymer. The nc-AFM images highlight the long-range order over areas of at least 300×300 nm . As required for a 2D polymer, the pore sizes are monodisperse, except for the regions where the network is somewhat stretched because it spans over protrusions. Together with a previous report on the nature of the cross-links in this network, the structural information provided herein leaves no doubt that a 2D polymer has been synthesized under ambient conditions at an air/water interface.

This work describes a two-dimensional polymerization at an air/water interface and provides, for the first time, direct spectroscopic evidence for the kind of crosslinks formed and for the conversion reached in a covalently bonded monolayer sheet. This evidence was obtained through a combination of a variety of monolayer characterization techniques before and after transfer onto solid substrates, in particular by tip-enhanced Raman spectroscopy (TERS) and TERS mapping after transfer of both the monomer and polymer monolayer onto Au(111). This work is a major advance for the field of 2D polymers synthesized at the air/water interface as it, in principle, allows estimation of the crystallinity by percolation theory and the location of regions with defects.

We report an investigation of interfacial fluorinated hydrocarbon (carboxylic-fantrip) monolayers by nanoscale imaging using tip-enhanced Raman spectroscopy (TERS) and density functional theory (DFT) calculations. By comparing TERS images of a sub-monolayer prepared by spin-coating and a π-π-stacked monolayer on Au(111) in which the molecular orientation is confined, specific Raman peaks shift and line widths narrow in the transferred LB monolayer. Based on DFT calculations that take into account dispersion corrections and surface selection rules, these specific effects are proposed to originate from π-π stacking and molecular orientation restriction. TERS shows the possibility to distinguish between a random and locked orientation with a spatial resolution of less than 10 nm. This work combines experimental TERS imaging with theoretical DFT calculations and opens up the possibility of studying molecular orientations and intermolecular interaction at the nanoscale and molecular level.

A Langmuir-Blodgett film consisting of a dense array of trifunctional monomers bearing three 1,8-diazaanthracene units is polymerized at an air/water interface or after transfer on solid substrates. The transfer does not affect the excimer fluorescence of the film, indicating that the monomers' packing with their diazaanthracene units stacked face-to-face is retained-a prerequisite for successful polymerization. The monomer film can be polymerized in confined areas on solid substrates by UV irradiation with a confocal microscope laser. The underlying chemistry of the polymerization, a [4+4]-cycloaddition of the diazaanthracene units, leads to disappearance of the fluorescence in the irradiated regions which enables writing into the monolayer on a µm scale-thus the term "molecular paper." The reaction can be reversed by heating which leads to a recovery of the fluorescence and to erasing of the writing. Alternative pathways for this phenomenon are discussed and control experiments are conducted to rule them out.