Improvements of microarray techniques for genotyping purposes have focused on increasing the reliability of this method. Here we report the development of a genotyping method where a microarray was spotted with stemloop probes, especially designed to optimize the hybridization specificity of complementary DNA sequences. This accurate method was used to screen for four common disease-causing mutations involved in a neurological disorder called Charcot-Marie-Tooth disease (CMT). Healthy individuals' and patients' DNA were amplified and labeled by PCR and hybridized on microarray. The spot signal intensities were 81 to 408 times greater for perfect compared with mismatched target sequences, differing by only one nucleotide (discrimination ratio) for healthy individual "homozygous" DNA. On the other hand, "heterozygous" mutant DNA samples gave rise to signal intensity ratios close to 1, as expected. The genotypes obtained by this method were perfectly consistent with those determined by direct PCR sequencing. Cross-hybridization rates were very low, resulting in further multiplexing improvements. In this study, we also demonstrated the feasibility of real-time hybridization detection of labeled synthetic oligonucleotides with concentrations as low as 2.5 nM.

We previously developed a highly specific method for detecting SNPs with a microarray-based system using stem-loop probes. In this paper we demonstrate that coupling a multiplexing procedure with our microarray method is possible for the simultaneous detection and genotyping of four point mutations, in three different genes, involved in Charcot-Marie-Tooth disease. DNA from healthy individuals and patients was amplified, labeled with Cy3 by multiplex PCR; and hybridized to microarrays. Spot signal intensities were 18 to 74 times greater for perfect matches than for mismatched target sequences differing by a single nucleotide (discrimination ratio) for “homozygous” DNA from healthy individuals. “Heterozygous” mutant DNA samples gave signal intensity ratios close to 1 at the positions of the mutations as expected. Genotyping by this method was therefore reliable. This system now combines the principle of highly specific genotyping based on stem-loop structure probes with the advantages of multiplex analysis.

No abstract