A simple solvothermal decomposition of bismuth dithiocarbamate complex in oleylamine, oleic acid, and hexadecylamine at 180 °C, yielded bismuth sulphide nanomaterials of different morphologies represented as Bi
2
S
3
(OAm), Bi
2
S
3
(OAc) and Bi
2
S
3
(HDA) respectively. The bismuth complex, used as the single source precursor, was synthesized and characterised by elemental analysis, FTIR, and NMR spectroscopic techniques. The spectroscopic and micro analysis confirmed the proposed compound, while the as-prepared nanoparticles were characterized using UV-visible spectroscopy, X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and energy dispersive spectrometer (EDS). The effects of the different solvent media on the structural properties of the obtained Bi
2
S
3
were investigated. An orthorhombic phase bismuthinite of varying intensities were obtained, with an indication that a bias of orientations existed in the (2 1 1) crystallographic planes in the Bi
2
S
3
(OAm) compared to the characteristic (1 3 0) diffraction peak of Bi
2
S
3
. The microscopic analysis showed a correlation between the nanoparticles' morphology and the type of solvent used, which also implied that the properties of Bi
2
S
3
were affected by the solvent medium.
Background
A large volume of dye molecules finds its way into the environment, accumulates in water bodies, and makes the aquatic system unsafe to human health. Due to the complex nature of these dye materials, most of the conventional techniques are not effective for their removal. Semiconductor photocatalysis has emerged as a promising technique for the destruction of organic pollutants under UV or visible light irradiation. Among the semiconductors, Bi2S3 is widely employed in photocatalysis due to its non-toxicity and chemical stability. However, one of its problems is the high recombination rate of the charge, and various methods have been employed to enhance the photo-reactivity. One of these methods is the incorporation of transition elements.
Results
Herein, a facile solvothermal method was used to prepare Bi2S3 nanorods and needle- shaped Sn doped Bi2S3, using bismuth(III) tris(N-phenyldithiocarbamate) as a single-source precursor. The prepared nanomaterials were characterized, and used as efficient photocatalyst for the photo enhanced degradation of methylene blue (MB) dye under visible light irradiation. The nanomaterials exhibited very good photocatalytic activity towards the photo degradation of MB, showing a degradation rate of up to 83% and 94% within 150 min for the pristine and Sn doped Bi2S3, respectively.
Conclusion
The enhancement in the photocatalytic activity of the Sn doped Bi2S3 was attributed to the suppression in the recombination rate of the electron‐hole pairs, due to the formation of new energy level below the CB, that was capable of altering the equilibrium concentration of the carrier. This confirmed that Sn doped Bi2S3 could be utilized as valuable cost-efficient catalysts for eliminating methyl blue from aqueous solutions and also possible candidates in environmental pollution treatment.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.