Stresses in flex spline/gear cup in harmonic drives with involute toothed gear pair and conventional strain wave generating cam are analyzed using finite element method in ANSYS® environment and experiments. The most innovative part of this investigation is establishing the evidence of secondary contacts and probable load shared by those contacts experimentally over the finite element analysis. Aiming at the performance improvement of gearing in harmonic drives, with involute toothed gear pair, the investigations are carried out through the following analyses. (a) Initial stresses in flex gear cup due to cam insertion only. (b) Stresses in flex gear cup at no load in fully assembled harmonic drive components i.e. flex gear, ring gear, and strain wave generating cam. (c) Stresses in flex gear cup at full load passing through the two pitch points, i.e. the intersection points of ring gear pitch circle, flex gear pitch curve, and major axis on both sides. Finally, (d) stresses in flex gear cup at full load distributed over all possible primary and secondary contacts, in proportion to their contact intensities. Recorded strains of the flex-gear cup while the cam being rotated showed very good agreement with the results obtained by finite element analysis with proper modeling of loading.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.