Variable interfacial tension could be desirable for many applications. Beyond classical stimuli like temperature, we introduce an electrochemical approach employing polymers. Hence, aqueous solutions of the nonionic–cationic block copolymer poly­(ethylene oxide)114-b-poly­{[2-(methacryloyloxy)­ethyl]­diisopropylmethylammonium chloride}171 (i.e., PEO114-b-PDPAEMA171 with a quaternized poly­(diisopropylaminoethyl methacrylate) block) were investigated by emerging drop measurements and dynamic light scattering, analyzing the PEO114-b-qPDPAEMA171 impact on the interfacial tension between water and n-decane and its micellar formation in the aqueous bulk phase. Potassium hexacyanoferrates (HCFs) were used as electroactive complexants for the charged block, which convert the bishydrophilic copolymer into amphiphilic species. Interestingly, ferricyanides ([Fe­(CN)6]3–) act as stronger complexants than ferrocyanides ([Fe­(CN)6]4–), leading to an insoluble qPDPAEMA block in the presence of ferricyanides. Hence, bulk micellization was demonstrated by light scattering. Due to their addressability, in situ redox experiments were performed to trace the interfacial tension under electrochemical control, directly utilizing a drop shape analyzer. Here, the open-circuit potential (OCP) was changed by electrolysis to vary the ratio between ferricyanides and ferrocyanides in the aqueous solution. While a chemical oxidation/reduction is feasible, also an electrochemical oxidation leads to a significant change in the interfacial tension properties. In contrast, a corresponding electrochemical reduction showed only a slight response after converting ferricyanides to ferrocyanides. Atomic force microscopy (AFM) images of the liquid/liquid interface transferred to a solid substrate showed particles that are in accordance with the diameter from light scattering experiments of the bulk phase. In conclusion, the present results could be an important step toward economic switching of interfaces suitable, e.g., for emulsion breakage.

The controlled growth of surface‐modifying polymer films by electrodeposition often fails because of the lack of redox activity of these compounds. Here, electroactive complexants help to electrodeposit non‐electroactive polymers. Hence, we investigate the counterion‐induced electrodeposition of polyelectrolytes: three quaternized poly(N,N‐dialkylaminoethyl methacrylate)s (qPDAAEMA), in particular their methyl, ethyl, and isopropyl derivatives (i. e. qPDMAEMA, qPDEAEMA, and qPDPAEMA), provide transparent solutions in the presence of hexacyanoferrate(II) (ferrocyanide) at specific concentration windows of the KCl supporting electrolyte. Below a certain KCl concentration, insolubility dominates irrespective of the hexacyanoferrate valency, whilst above an upper threshold, full solubility is observed. Between these limits, oxidation reversibly electrodeposits polymer/hexacyanoferrate(III) (ferricyanide) complexes. Hydrodynamic voltammetry (and data analysis using in‐house software) provides access to the deposition efficiency (DE). qPDEAEMA with ethyl substituents shows highest DEs; larger or smaller substituents fall short because of a balance between “hydrophobicity” and charge separation, shifting the window toward smaller salt concentrations with increasing alkyl size. We always observe a DE maximum close to the minimum salt concentration, whilst electrochemical quartz crystal microbalance (EQCM) measurements indicate a change in film water content close to the maximum. These effects, being also discussed in terms of polymer conformation, can direct the future engineering of electroassisted coatings.