The sliding clamps of bacteriophage T4 (gp45), Escherichia coli (beta clamp), and yeast (PCNA) are required for processive DNA synthesis by their cognate DNA polymerases. The X-ray crystal structures of all three of these clamps have been shown to be closed, circular complexes. This paper reports investigations of the solution structure of bacteriophage T4 gp45 by analytical ultracentrifugation, fluorescence, and hydrodynamic modeling. Mutants of gp45 with inter- and intrasubunit disulfide bonds were created to alter the solution structure of gp45, with additional mutagenesis used to investigate the importance of the proline-rich loop region found between the two domains of each gp45 monomer. The wild-type gp45 trimer assembles from monomers cooperatively with a dissociation constant of 0.21 microM2 and values between 0.088 and 0. 32 microM2 for the mutants. Velocity ultracentrifugation experiments showed that wild-type gp45 possesses a sedimentation coefficient strongly dependent on concentration, typical of asymmetric or elongated molecules, that when extrapolated to zero concentration yields a sedimentation coefficient of 4.0 S. The loop and the disulfide mutants exhibited sedimentation coefficients with little concentration dependence, typical of symmetric or spherical molecules, that when extrapolated to zero concentration yielded sedimentation coefficients of 4.4-4.8 S. The lower sedimentation coefficient in the former case is consistent with wild-type gp45 being more asymmetric or elongated than the mutant forms. Fluorescence-resonance energy-transfer experiments were used to measure the distance between two amino acids (W91 and V162C-coumarin) on opposite sides of the gp45 subunit interface. For an intrasubunit disulfide mutant, the distance between these two amino acids was determined to be 19 A (14 A in the X-ray crystal structure), consistent with a closed complex. For the mutants without intrasubunit disulfides, the efficiency of fluorescence-resonance energy transfer was in accord with a model of gp45 being an open complex composed of two closed subunit interfaces and a third open interface separated by a distance of 35-38 A. The collective data supplemented with hydrodynamic modeling were consistent with gp45 subunit separation achieved within the plane of the gp45 ring.

The gene product 61 primase protein from bacteriophage T4 was expressed as an intein fusion and purified to homogeneity. The primase binds one zinc ion, which is coordinated by four cysteine residues to form a zinc ribbon motif. Factors that influence the rate of priming were investigated, and a physiologically relevant priming rate of approximately 1 primer per second per primosome was achieved. Primase binding to the single-stranded binding protein (1 primase:4 gp32 monomers; K(d) approximately 860 nM) and to the helicase protein in the presence of DNA and ATP-gamma-S (1 primase:1 helicase monomer; K(d) approximately 100 nM) was investigated by isothermal titration calorimetry (ITC). Because the helicase is hexameric, the inferred stoichiometry of primase binding as part of the primosome is helicase hexamer:primase in a ratio of 1:6, suggesting that the active primase, like the helicase, might have a ring-like structure. The primase is a monomer in solution but binds to single-stranded DNA (ssDNA) primarily as a trimer (K(d) approximately 50-100 nM) as demonstrated by ITC and chemical cross-linking. Magnesium is required for primase-ssDNA binding. The minimum length of ssDNA required for stable binding is 22-24 bases, although cross-linking reveals transient interactions on oligonucleotides as short as 8 bases. The association is endothermic at physiologically relevant temperatures, which suggests an overall gain in entropy upon binding. Some possible sources of this gain in entropy are discussed.

No abstract

Caulobacter crescentus contains one of the two known prokaryotic DNA methyltransferases that lacks a cognate endonuclease. This endogenous cell cycle regulated adenine DNA methyltransferase (CcrM) is essential for C. crescentus cellular viability. DNA methylation catalyzed by CcrM provides an obligatory signal for the proper progression through the cell cycle. To further our understanding of the regulatory role played by CcrM, we sought to investigate its biophysical properties. In this paper we employed equilibrium ultracentrifugation, velocity ultracentrifugation, and chemical cross-linking to show that CcrM is dimeric at physiological concentrations. However, surface plasmon resonance experiments in the presence of S-adenosyl-homocysteine evince that CcrM binds as a monomer to a defined hemi-methylated DNA substrate containing the canonical methylation sequence, GANTC. Initial velocity experiments demonstrate that dimerization of CcrM does not affect DNA methylation. Collectively, these findings suggest that CcrM is active as a monomer and provides a possible in vivo role for dimerization as a means to stabilize CcrM from premature catabolism.

Meprins, multimeric metalloproteases expressed in kidney and intestinal epithelial cells as well as in certain leukocytes and cancer cells, have the ability to hydrolyze a variety of growth factors, vasoactive peptides, cytokines, and extracellular matrix proteins. The meprin B isoform exists primarily as a cell-surface homooligomer composed of disulfide-linked, multidomain ␤-subunits. To gain insight into how the tertiary and quaternary structure of meprin B affects function, the disulfide-bonding pattern and sites of domain-domain interactions were investigated using sedimentation equilibrium ultracentrifugation, cross-linking, and mass spectrometry techniques. Three symmetrical intersubunit disulfide bonds were identified in the noncatalytic interaction domains; two in the MAM (meprin, A-5 protein, protein-tyrosine phosphatase ) domain and one in the TRAF (tumor necrosis factor receptorassociated factor) domain. These disulfide bridges are unique for the known homophilic interactions of these domains. Mutation of any of the intersubunit cysteine residues resulted in the inability of meprin B to form disulfide-linked dimers. The four cysteines of the protease domain formed intradomain disulfide bonds. The MAM domain also had one intradomain disulfide bond and one free cysteine. Cross-linking studies of the meprin B dimer with the amine-reactive cross-linker disuccinimidyl suberate revealed inter-and intradomain contacts within the protein, including prosequence-prosequence, protease-TRAF, protease-epidermal growth factor, and TRAF-TRAF interactions. From these observations, a model of the meprin B dimer structure is proposed that provides insight into the relationship between structure and function of this isoform.