BackgroundHealthcare-acquired infections by pathogenic microorganisms including viruses represent significant health concern worldwide. Next to direct transmission from person-to-person also indirect transmission from contaminated surfaces is well documented and important route of infections. Here, we tested antiviral properties of hybrid coating containing silver, copper and zinc cations that was previously shown to be effective against pathogenic bacteria including methicillin-resistant Staphylococcus aureus. Hybrid coatings containing silver, copper and zinc cations were prepared through radical polymerization via sol-gel method and applied on glass slides or into the wells of polymethylmethacrylate plates. A 10 μl droplet of several viruses such as human immunodeficiency virus type 1 (HIV-1), influenza, dengue virus, herpes simplex virus, and coxsackievirus was added to coated and uncoated slides or plates, incubated usually from 5 to 240 min and followed by titer determination of recovered virus.ResultsScanning electron microscopy analysis showed better adhesion of coatings on glass surfaces, which resulted in 99.5–100 % HIV-1 titer reduction (3.1 ± 0.8 log10TCID50, n = 3) already after 20 min of exposure to coatings, than on coated polymethylmethacrylate plates with 75–100 % (1.7 ± 1.1 log10TCID50, n = 3) and 98–100 % (2.3 ± 0.5 log10TCID50, n = 3) HIV-1 titer reduction after 20 and 120 min of exposure, respectively. Slower virucidal kinetics was observed with other enveloped viruses, where 240 min exposure to coated slides lead to 97 % (dengue), 100 % (herpes simplex) and 77 % (influenza) reduction in virus titers. Interestingly, only marginal reduction in viral titer after 240 min of exposure was noticed for non-enveloped coxsackie B3 virus.ConclusionsOur hybrid coatings showed virucidal activity against HIV and other enveloped viruses thus providing further findings towards development of broad-spectrum antimicrobial coating suitable for surfaces in healthcare settings.

No abstract

No abstract

Poly(ethylene terephthalate)—PET, is one of the most common polyesters, widely used in biomedical applications ranging from catheters to stents, vascular grafts, heart valves, sutures, and scaffolds. PET surface modification is necessary to impart desired properties for biomedical applications, making the polymer biocompatible, noncytotoxic and antibacterial that can preferably resist biofilm formation caused by pathogenic bacteria. A novel approach to anticorrosive wet chemical surface modification of PET by insertion of alkyl and hydroxyl groups was achieved by using Grignard reagents and confirmed by several different characterization methods including Fourier transform infrared spectroscopy (FTIR), water contact angle (WCA) measurement, free surface energy (FSE) measurement, scanning electron microscopy (SEM), and atomic force microscopy (AFM). High antibacterial efficiency against four different types of biofilm active, pathogenic bacterial strains namely: Staphylococcus aureus, Escherichia coli, methicillin‐resistant S. aureus (MRSA), and Pseudomonas aeruginosa was established on the modified PET surface. Biocompatibility higher than 84% of the modified samples has been proved. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2017, 134, 44990.

No abstract

No abstract

No abstract

No abstract