Full-length Drosophila myosin 7a (myosin 7a-FL) has a complex tail containing a short predicted coiled coil followed by a MyTH4-FERM domain, an SH3 domain, and a C-terminal MyTH4-FERM domain. Myosin 7a-FL expressed in Sf9 cells is monomeric despite the predicted coiled coil. We showed previously that Subfragment-1 (S1) from this myosin has MgATPase of Vmax Ϸ 1s ؊1 and KATPase Ϸ 1 M actin. We find that myosin 7a-FL has Vmax similar to S1 but KATPase Ϸ 30 M. Thus, at low actin concentrations (5 M), the MgATPase of S1 is fully activated, whereas that of myosin 7a-FL is low, suggesting that the tail regulates activity. Electron microscopy of myosin 7a-FL with ATP shows the tail is tightly bent back against the motor domain. Myosin 7a-FL extends at either high ionic strength or without ATP, revealing the motor domain, lever, and tail. A series of C-terminal truncations show that deletion of 99 aa (the MyTH7 subdomain of the C-terminal FERM domain) is sufficient to abolish bending, and the KATPase is then similar to S1. This region is highly conserved in myosin 7a. We found that a double mutation in it, R2140A-K2143A, abolishes bending and reduces KATPase to S1 levels. In addition, the expressed C-terminal FERM domain binds actin with Kd Ϸ 30 M regardless of ATP, similar to the KATPase value for myosin 7a-FL. We propose that at low cellular actin concentrations, myosin 7a-FL is bent and inactive, but at high actin concentrations, it is unfolded and active because the Cterminal FERM domain binds to actin.regulation ͉ electron microscopy ͉ ATPase activity

Muscle force results from the interaction of the globular heads of myosin-II with actin filaments. We studied the structure-function relationship in the myosin motor in contracting muscle fibers by using temperature jumps or length steps combined with time-resolved, low-angle X-ray diffraction. Both perturbations induced simultaneous changes in the active muscle force and in the extent of labeling of the actin helix by stereo-specifically bound myosin heads at a constant total number of attached heads. The generally accepted hypothesis assumes that muscle force is generated solely by tilting of the lever arm, or the light chain domain of the myosin head, about its catalytic domain firmly bound to actin. Data obtained suggest an additional force-generating step: the "roll and lock" transition of catalytic domains of non-stereo-specifically attached heads to a stereo-specifically bound state. A model based on this scheme is described to quantitatively explain the data.

Investigations were conducted into the biochemical and mechanical states of cross-bridges during isometric muscle contraction. Rapid length steps (3 or 6 nm hs(-1)) were applied to rabbit psoas fibers, permeabilized and isometric, at either 12 degrees C or 20 degrees C. Fibers were activated by photolysis of P(3)-1-(2-nitrophenyl)-ethyl ester of ATP infused into rigor fibers at saturating Ca(2+). Sarcomere length, tension, and phosphate release were recorded-the latter using the MDCC-PBP fluorescent probe. A reduction in strain, induced by a rapid release step, produced a short-lived acceleration of phosphate release. Rates of the phosphate transient and that of phases 3 and 4 of tension recovery were unaffected by step size but were elevated at higher temperatures. In contrast the amplitude of the phosphate transient was smaller at 20 degrees C than 12 degrees C. The presence of 0.5 or 1.0 mM added ADP during a release step reduced both the rate of tension recovery and the poststep isometric tension. A kinetic scheme is presented to simulate the observed data and to precisely determine the rate constants for the elementary steps of the ATPase cycle.