No abstract

No abstract

This study demonstrates the potential of using hydrogel material for encapsulation of plant poplyphenols to improve their functionality and stability in food products.

This paper describes the results of the round robin experiment “Bead production technologies” carried out during the COST 840 action “Bioencapsulation Innovation and Technologies” within the 5th Framework Program of the European Community. In this round robin experiment, calcium alginate hydrogel beads with the diameter of (800 ± 100) μm were produced by the most common bead production technologies using 0.5–4 mass % sodium alginate solutions as starting material. Dynamic viscosity of the alginate solutions ranged from less than 50 mPa s up to more than 10000 mPa s. With the coaxial air-flow and electrostatic enhanced dropping technologies as well as with the JetCutter technology in the soft-landing mode, beads were produced from all alginate solutions, whereas the vibration technology was not capable to process the high-viscosity 3 % and 4 % alginate solutions. Spherical beads were generated by the electrostatic and the JetCutter technologies. Slightly deformed beads were obtained from high-viscosity alginate solutions using the coaxial airflow and from the 0.5 % and 2 % alginate solutions using the vibration technology. The rate of bead production using the JetCutter was about 10 times higher than with the vibration technology and more than 10000 times higher than with the coaxial air-flow and electrostatic technology.

The subject of this study is the development of flavor wax formulations aimed for food and feed products. The melt dispersion technique was applied for the encapsulation of ethyl vanillin in wax microcapsules. The surface morphology of microparticles was investigated using scanning electron microscope (SEM), while the loading content was determined by HPLC measurements. This study shows that the decomposition process under heating proceeds in several steps: vanilla evaporation occurs at around 200 °C, while matrix degradation starts at 250 °C and progresses with maxima at around 360, 440 and 520 °C. The results indicate that carnauba wax is an attractive material for use as a matrix for encapsulation of flavours in order to improve their functionality and stability in products.

in the second case (28.80 ± 0.07 vs. 20.46 ± 0.39 %). The fraction obtained by the ultrasound pretreatment containing peptides with a molecular weight between 1 and 10 kDa demonstrated the strongest ABTS radical scavenging efficacy among the fractions (97.54 ± 0.30) with IC 50 value of 4.31 mg/mL. Compared with single-enzyme processes, the two-stage enzymatic processes did not significantly improve both antioxidant and functional hydrolysates' properties.

No abstract

No abstract