No abstract

No abstract

Purpose The purpose of this paper is the presentation and research of a novel robot vision system, which uses laser dynamic triangulation, to determine three-dimensional (3D) coordinates of an observed object. The previously used physical operation principle of discontinuous scanning method is substituted by continuous method. Thereby applications become possible that were previously limited by this discretization. Design/methodology/approach The previously used prototype No. 2, which uses stepping motors to realize a discontinuous laser scan, was substituted by the new developed prototype No. 3, which contains servomotors, to achieve a continuous laser scan. The new prototype possesses only half the width and turns out to be significantly smaller and therefore lighter than the old one. Furthermore, no transmissions are used, which reduce the systematic error of laser positioning and increase the system reliability. Findings By using a continuous laser scan method instead of discontinuous laser scan method, dead zones in the laser scanner field can be eliminated. Thereby, also by changing the physical operation principle, the implementation of applications is allowed, which previously was limited by the fixed step size or by the object distance under observation. By using servomotors instead of stepping motors, also a significant reduced positioning time can be accomplished maintaining the relative positioning error less than 1 per cent. Originality/value The originality is based on the substitution of the physical operation principle of discontinuous by continuous laser scan. The previously used stepping motors discretized the laser scanner field and thereby produced dead zones, where 3D coordinates cannot be detected. These stepping motors were substituted by servomotors to revoke these disadvantages and provide a continuous laser scan, where dead zones in the field of view get eliminated and the step response of the laser scanner accelerated.

No abstract

Purpose The purpose of this paper is to present a novel application for a newly developed Technical Vision System (TVS), which uses a laser scanner and dynamic triangulation, to determine the vitality of agriculture vegetation. This vision system, installed on an unmanned aerial vehicle, shall measure the reflected laser energy and thereby determine the normalized differenced vegetation index. Design/methodology/approach The newly developed TVS shall be installed on the front part of the unmanned aerial vehicle, to perform line-by-line scan in the vision system field-of-view. The TVS uses high-quality DC motors, instead of previously researched low-quality DC motors, to eliminate the existence of two mutually exclusive conditions, for exact positioning of a DC motor shaft. The use of high-quality DC motors reduces the positioning error after control. Findings Present paper emphasizes the exact laser beam positioning in the field-of-view of a TVS. By use of high-quality instead of low-quality DC motors, a significant reduced positioning time was achieved, maintaining the relative angular position error less than 1 per cent. Best results were achieved, by realizing a quasi-continuous control, using a high pulse-width modulated duty cycle resolution and a high execution frequency of the positioning algorithm. Originality/value The originality of present paper is represented by the novel application of the newly developed TVS in the field of agriculture. The vitality of vegetation shall be determined by measuring the reflected laser energy of a scanned agriculture zone. The paper’s main focus is on the exact laser beam positioning within the TVS field-of-view, using high-quality DC motors in closed-loop position control configuration.

No abstract

No abstract

No abstract