Lipids are naturally occurring organic compounds that can be classified into a number of types based on their solubility in nonpolar organic solvents, and are generally insoluble in water. The great structural variety of these various types of lipids has led them to be components of many different biological substances such as oils, waxes, cellular membranes, tissues and biological fluids. The use of capillary electrophoresis (CE) for the study of lipids during the past 30 years has been relatively rare when compared to its use for other classes of biomolecules, primarily due to their insolubility in water. However, a number of interesting studies have been conducted, and as part of this review, we will present the different approaches that were used, which mainly consist of micellar kinetic chromatography and non-aqueous CE. The main advantages of the use of these techniques compared to GC is the very simple sample preparation that is required and, compared to LC, the very robust and quick separations that can be obtained. In this review, we present the various methods that have been reported in the literature that have been used for the study of fatty acids, phospholipids, glycerides, eicosanoids and sterols, with the inclusion of various tables presenting descriptions of the CE methods used as well as the methods of detection, including UV absorbance, fluorescence, mass spectrometry, and conductivity. This review aims to demonstrate that CE can be easily used for the analysis of lipids.

Capillary electrophoresis coupled to LED-induced fluorescence detection is a robust and sensitive technique used for amino acids (AA) analysis in biological media, after labeling with 3-(4-carboxybenzoyl)quinoline-2-carboxaldehyde (CBQCA). We wanted to quantitate in plasma tryptophan (Trp), tyrosine (Tyr), valine (Val), and isoleucine (Ile). Among the different labeled AA-CBQCA, Trp has the lowest fluorescence yield, which makes its detection and quantification very difficult in biological samples such as plasma. We tried to improve Trp analysis by CE/LED-induced fluorescence detection to its maximal sensitivity by using large volume sample stacking as a preconcentration step in our analytical protocol. At pH 9.5, this step caused a drop in resolution during the separation of the four AAs and it was therefore necessary to work at pH 10. We have found that Tyr, Val, Ile, and Trp are detected and well separated from the other AAs, but Trp cannot be quantified in plasma samples, mainly because of the low fluorescence yield of the Trp-CBQCA derivative. The recorded LOD is 0.18 μM for Trp-CBQCA in standard solution with a resolution between Trp and Tyr of 1.2, while the LOD is 6 μM in plasma with the same resolution. Trp, Tyr, Val, and Ile are, however, efficiently quantified when using a 3 M acetic acid electrolyte and CE associated with capacitively coupled contactless conductivity detection, which also has the advantage of not requiring derivatization or large volume sample stacking. This article demonstrates, for the CE user, that quantitative analysis of these four AA in mouse plasma can be performed by CE-fluorescence after CBQCA labeling, with the exception of Trp. It can be advantageously replaced by CE/capacitively coupled contactless conductivity detection, the only efficient one for Trp, Tyr, Val, and Ile quantification. In this case, the LOD for Trp is 2 μM. The four AAs are separated with resolution with neighbors above 1.5.