A method is described for the quantitation of total human and male DNA. Q-TAT utilizes end-point, multiplex polymerase chain reaction (PCR) amplification of the amelogenin and SRY loci to quantify DNA and incorporates a cloned nonhuman template to detect PCR inhibition. Standard curves of fluorescence from amelogenin or SRY amplicons were generated from amplification of known amounts of NIST traceable SRM-female or SRM-male DNA. Curves showed good linearity up to 500 pg of SRM-template (R(2) > 0.99) and reliably estimated total and male DNA content in casework samples. The nonhuman pRL(null) template included in each PCR was a sensitive indicator of known PCR inhibitors including EDTA, hemin, blue denim dye, and humic acid. Finally, the SRY amplicon was a sensitive indicator of male DNA and, in mixtures, could reliably estimate male DNA present in an excess of female DNA. The Q-TAT multiplex is a reliable quantitation method for forensic DNA typing.

An alternate method for quantitation of human genomic DNA is presented. Quantitative template amplification technology (abbreviated "Q-TAT") estimates the quantity of human DNA present in an extract by comparing fluorescence in X and Y amplicons produced from unknowns with fluorescence in a standard curve amplified from known quantities of reference DNA. Q-TAT utilizes PCR and electrophoresis with fluorescent detection/quantitation, precluding the need for new instrumentation, methodology, or quality assurance associated with slot-blot or real-time PCR. In a comparison study incorporating shared samples, Q-TAT was found to be more sensitive than widely used slot-blot methods but somewhat less sensitive than real-time PCR. Among samples containing DNA concentrations ranging from 100 pg/microL to 2-4 ng/microL, Q-TAT produced DNA concentration estimates that agreed reasonably well with either Quantiblot or real-time PCR. Q-TAT was reproducible with a typical coincidence of variation of about 35%. Quantitation of human DNA in this study involved summing fluorescence in X and Y amplicons in unknowns and quantitation standards. However, analyzing fluorescence in X and Y amplicons individually could allow estimates of male and female DNA present in mixtures to be made. Moreover, since X and Y amplicons exhibit sizes of 210 and 216 bp, respectively, the integrity as well as the concentration of the genomic DNA template can be assessed. Q-TAT represents an alternate method useful for the quantitation of human genomic DNA prior to amplification of STR loci used for identity testing purposes. The method uses existing equipment and procedures in conjunction with a well-characterized DNA standard to produce concentration estimates for unknowns that reliably produce STR profiles suitable for analysis.

Evidentiary samples submitted to a forensic DNA laboratory occasionally yield DNA that is degraded. Samples of intact chromosomal DNA (both nuclear and mitochondrial) were subjected to a heating protocol to induce DNA degradation. The DNAs were then analyzed using a multiplex PCR assay that amplifies targets of low and high molecular weight on the X/Y and mitochondrial chromosomes. If degradation is random, the amplification of larger DNA targets should be more adversely affected by degradation than smaller targets. In nuclear and mitochondrial DNA from a male donor, exhibiting degradation, DNA quantity estimates based upon higher molecular weight amplicons (HMW) are significantly lower than estimates made using low molecular weight (LMW) Q-TAT amplicons. DNA degradation estimated using this approach correlated well with actual fluorescence associated with HMW and LMW STR alleles amplified from the same genomic DNA templates. Q-TAT is thus useful not only as a quantitation tool, but also as an indicator of template degradation.