Mixed monolayers of distearoylphosphatidylcholine (DSPC) and a poly(ethylene glycol)-(PEG)-grafted distearoylphosphatidylethanolamine with a PEG molecular weight of 2000, DSPE-PEG2000, spread on phosphate-buffered saline (PBS) were used as models of bio-non-fouling membrane-mimetic surfaces in order to visualize the lateral distribution of PEG2000-phospholipid in the host phospholipid matrix. Epifluorescence microscopy (EFM) was used to locate DSPE-PEG2000 molecules in the DSPC matrix by detecting the fluorescence from a fluorescein fluorophore attached to the distal end of the PEG2000 chain. Comparative analysis of surface pressure-area isotherms and EFM images revealed that DSPE-PEG2000 mixes nonideally with DSPC in monolayers on a PBS subphase. A transition from a phase-separated monolayer to a homogeneous mixture was observed with increasing surface pressure and PEG content. The effect of nonideal mixing behavior of DSPE-PEG2000 on its lateral distribution in the DSPC matrix was interpreted in terms of excluded volume interactions between the PEG2000 chains and a mismatch in the tilt of aliphatic chains on DSPC and DSPE-PEG2000 molecules.

No abstract

To investigate the effect of saline on miscibility, phase, and conformational transitions in binary mixtures of a succinyl-phosphoethanolamine bearing C(16) aliphatic chains, DPPE-succinyl, and a poly(ethylene glycol) (PEG)-phospholipid conjugate with a PEG molecular weight of 2000, DPPE-PEG2000, we have compared the properties of monolayers spread on water and on phosphate buffered saline (PBS). A comparative analysis of monolayer surface pressure, surface potential, compressibility, and epifluorescence microscopy data has revealed that spreading on PBS induces unfavorable interactions between the two phospholipids, which stabilizes immiscible phases in mixed monolayers. Strikingly, the conformational transition in grafted PEG2000 chains on PBS could not be easily described by the existing interpretive schemes. Plausibly, this transition becomes partially impaired due to interactions with PBS. Thus, saline has a significant effect on miscibility, phase, and conformational transitions in these PEG-grafted monolayers bearing C(16) aliphatic chains, which may have implications for understanding the behavior of PEG-grafted phospholipid surfaces in aqueous media of biological relevance.

Mixed phospholipid monolayers hosting a poly(ethylene glycol) (PEG)-grafted distearoylphosphatidylethanolamine with a PEG molecular weight of 5000 (DSPE-PEG5000) spread at the air/water interface were used as model systems to study the effect of PEG-phospholipids on the lateral structure of PEG-grafted membrane-mimetic surfaces. DSPE-PEG5000 has been found to mix readily with distearoylphosphoethanolamine-succinyl (DSPE-succynil), a phospholipid whose structure resembles closely that of the phospholipid part of the DSPE-PEG5000 molecule. However, properties of mixed monolayers such as morphology and stability varied significantly with DSPE-PEG5000 content. In particular, our surface pressure, epifluorescence microscopy (EFM), and Brewster angle microscopy (BAM) studies have shown that mixtures containing 1-9 mol % of DSPE-PEG5000 form stable condensed monolayers with no sign of microscopic phase separation at surface pressures above approximately 25 mN/m. Yet, at 1 mol % of DSPE-PEG5000 in mixed monolayers, the two components have been found to behave nearly immiscibly at surface pressures below approximately 25 mN/m. For monolayers containing 18-75 mol % of DSPE-PEG5000, a high-pressure transition has been observed in the low-compressibility region of their isotherms, which has been identified on the basis of continuous BAM imaging of monolayer morphology, as reminiscent of the collapse nucleation in a pure DSPE-PEG5000 monolayer. Thus, the comparative analysis of our surface pressure, EFM, and BAM data has revealed that there exists a rather narrow range of mixture compositions with DSPE-PEG5000 content between 3 and 9 mol %, where somewhat homogeneous distribution of DSPE-PEG5000 molecules and high pressure stability can be achieved. This finding can be useful to "navigating" through possible mixture compositions while developing guidelines to the rational design of membrane-mimetic surfaces with highly controlled bio-nonfouling properties.