In the construction of electronic nose devices, two groups of measurement setups could be distinguished when we take into account the design of electronic nose chambers. The simpler one consists of placing the sensors directly in the environment of the measured gas, which has an important advantage, in that the composition of the gas is not changed as the gas is not diluted. However, that has an important drawback in that it is difficult to clean sensors between measurement cycles. The second, more advanced construction, contains a pneumatic system transporting the gas inside a specially designed sensor chamber. A new design of an electronic nose gas sensor chamber is proposed, which consists of a sensor chamber with a sliding chamber shutter, equipped with a simple pneumatic system for cleaning the air. The proposal combines the advantages of both approaches to the sensor chamber designs. The sensors can be effectively cleared by the flow of clean air, while the measurements are performed in the open state when the sensors are directly exposed to the measured gas. Airflow simulations were performed to confirm the efficiency of clean air transport used for sensors’ cleaning. The demonstrated electronic nose applies eight Figaro Co. MOS TGS series sensors, in which a transient response caused by a change of the exposition to measured gas, and change of heater voltage, was collected. The new electronic nose was tested as applied to the differentiation between the samples of Ciboria batschiana fungi, which is one of the most harmful pathogens of stored acorns. The samples with various coverage, thus various concentrations of the studied odor, were measured. The tested device demonstrated low noise and a good level of repetition of the measurements, with stable results during several hours of repetitive measurements during an experiment lasting five consecutive days. The obtained data allowed complete differentiation between healthy and infected samples.

A 20-year study of a pine stand on post-agricultural land showed that woody debris in the form of organic matter can be successfully used to restore symbiotic mycorrhizal communities, as is the case with forest soils. Woody substrates restored organic matter in soils altered by long agricultural use and had a positive effect on the composition of mycobiota antagonistic to pathogens, especially to Heterobasidion annosum, the causal agent of the dangerous disease root and stump rot of many forest tree species, including stands of Pinus sylvestris (L.). In a study that started in 2001 in the forest district of Czarne Człuchowskie (northern Poland), the following organic materials were used: wood residues (W), sawdust (S), bark compost (B), and compost applied to the root zone during planting (G). The organic materials were spread in the form of mulch over the entire area during planting. After twenty years, it was found that the substrates used provided suitable growth conditions for mycobiome useful for pines. The addition of organic matter did not change the alpha biodiversity of the soil, but in the long term led to significant changes in the composition of mycobiota (beta biodiversity). The changes in the soil after the addition of organic material naturally accelerated the formation of the forest habitat. A number of fungi evolved that degraded added lignin and cellulose while being antagonists of H. annosum and other pine pathogens. In particular, the well-known hyperpathogens of the genus Trichoderma played an important role by promoting resistance of the soil environment to pathogens. Soil enrichment by bark compost and wood residues increased the relative abundance of Trichoderma more than fourfold.Mycorrhizal fungi became dominant in soil enriched with organic matter. After enriching the soil with bark compost, the relative abundance of Amphinema and Inocybe increased to 5%. The relative abundance of Russula in soil enriched with wood residues and sawdust increased to 9% and 5%, respectively. Mycorrhizal fungi, e.g., of the genus Ąmanita, Rusula, which formed root mycorrhizae, not only increased the root receiving area many times over, but also protected the roots (mechanically and chemically from pathogens). Altogether, the observed positive changes increase the chances that the first generation of pines will survive on the ground.

Heterobasidion annosum (Fr.) Bref. sensu lato (s.l.) is a dangerous forest pathogen causing root and butt rot disease in most conifers of the northern hemisphere. This pathogen is most widespread in the forests of Europe and North America. The economic impact on forestry related to tree mortality, reduction in timber yield, and wood rot is calculated in millions of dollars and euros. The genus Heterobasidion (Basidiomycota; Russulales) has been relatively recently separated into three genetically distinct groups (H. annosum, H. insulare and H. araucariae) comprising a total of 12 species and one newly described hybrid taxon. These species are the best studied in terms of the ecology, the physiology of control methods, and the tree’s resistance to the pathogen. The article gives an overview of the symptoms and the etiology of the disease and provides information on ways to recognize the disease and limit the economic damage.