To evaluate the effectiveness low-level laser therapy (LLLT) on the repair of the mid palatal suture, after rapid maxillary expansion (RME). A single-operator, randomized single-blind placebo-controlled study was performed at the Orthodontic Department at the Dental Hospital of Bellvitge. Barcelona University, Hospitalet de Llobregat, Spain. Thirty-nine children (range 6-12 years old), completed RME and were randomized to receive active LLLT (n = 20) or placebo (n = 19). The laser parameters and dose were 660 nm, 100 mW, CW, InGaAlP laser, illuminated area 0.26 cm(2), 332 mW/cm(2), 60 s to four points along midpalatal suture, and 30 s to a point each side of the suture. A total of seven applications were made on days 1, 7, 14, 28, 42, 56, and 70 of the retention phase RME. A cone beam computed tomography (CBCT) scan was carried out on the day of the first laser treatment, and at day 75, a second CBCT scan was performed. Two radiologists synchronized the slices of two scans to be assessed. P = 0.05 was considered to be statistically significant. At day 75 of the suture, the irradiated patients presented a greater percentage of approximate zones in the anterior (p = 0.008) and posterior (p = 0.001) superior suture-and less approximation in the posterior superior suture (p = 0.040)-than the placebo group. LLLT appears to stimulate the repair process during retention phase after RME.

Varying the wavelength with a reasonable dose in the target zone leads to obtaining the desired biological effect and achieving a reduction of the orthodontic treatment time, although there are studies that do not demonstrate any benefit according to their values.

Introduction: The overeruption of upper molars due to the premature loss of antagonist teeth can be treated with the help of miniscrews. The aim of this study was to evaluate the movement of a typodont molar according to the biomechanical approach used with miniscrews. Study design: The study was conducted with four plaster models filled with typodont wax. In each model we used one absolute anchorage on the palatal side and another on the buccal side in different positions, thus generating four different biomechanical systems. A force of 150 g was applied to each side of the resin tooth. Periapical radiographs were taken preintrusion and immediately after completion of the intrusion. Photographs were taken in both the sagittal and occlusal planes every 3 min. The radiographic films and photographs were measured and compared. Results: A vertical movement of the molar was observed in all the models, with system 4 showing the greatest movement. Rotation in the occlusal plane only occurred in system 2, while in system 1 there was a change in the axial axis of 37 degrees. Conclusions: The anchorage site and the combination of forces applied may determine the resulting tooth movement.

No abstract

These results back the finite element analysis model for force prediction.