a b s t r a c tWe present an experimental study of the kinematics of twist extrusion (TE) and show that TE has the following properties: (i) as in equal-channel angular pressing (ECAP), the mode of deformation in twist extrusion is simple shear. Unlike in ECAP, there are two shear planes; one of them is perpendicular and the other is parallel to the specimen axis. (ii) The following processes are present during twist extrusion: vortex-like flow with large strain gradient, stretching and mixing of metal particles. We argue that, due to these properties, TE opens possibilities for investigating and forming new microstructures. It has already been successfully used to obtain ultrafine-grained microstructures with good properties in Al, Cu and Ti alloys.

Potentialities of a new simple shear-based scheme of the solid-phase extrusion of polymers, named the equal channel multiple angular extrusion (ECMAE), for modification of semicrystalline polymer structure have been investigated by the example of low-and highdensity polyethylene (LDPE, HDPE), polyamide-6 (PA-6), and polytetrafluoroethylene (PTFE). The effects of velocity and extrusion temperature, plastic deformation intensity, and accumulated equivalent plastic strain value on properties of a number of crystallizing polymers have been studied. It has been shown that the highest strength characteristics are attained for the extrusion temperatures of (0.8-0.95) of the melting temperature and deformation velocity of (0.6-1.1) mm s 21 . For the ECMAE-processed specimens, the density, the enthalpy, and the melting temperature have become higher. In the oriented structure of semicrystalline polymers formed by the ECMAE, the lamellae are oriented along the extrudate axis.

High purity Al (99.99%) was subjected to severe plastic deformation through twist extrusion at room temperature. Microstructures were examined for 1 pass and 4 passes on the cross section perpendicular to the longitudinal axis of billets using optical microscopy and electron back scatter diffraction analysis. It was shown that a vortex-like material flow was observed on the cross section and this became more intense with increasing number of the pressing. After one pass, subgrain structures with low angle grain boundaries were developed throughout the section but after 4 passes, the microstructure consisted of grains surrounded by high angle boundaries with fraction of $70% in the edge parts. The average grain size at the edge parts is refined to $1:6 mm.

No abstract

High purity Al (99.99%) is subjected to severe plastic deformation (SPD) at room temperature using a process of twist extrusion (TE). The microstructure evolution and the related change in microhardness are examined with respect to imposed strain. It is shown that subgrains develop after the first TE pass with a size of $1:6 mm and this size remains essentially the same for further application of TE passes. However, dislocations become less visible within grains and grain boundaries become straight and well-defined with misorientation angle higher as the imposed strain is increased. The hardness increases with imposed strain when the magnitude of the strain is small. However, as the imposed strain is large, the hardness decreases due to a reduction of dislocations within grains. It is confirmed that these results obtained with TE are consistent with those reported using equal-channel angular pressing (ECAP) and high pressure torsion (HPT), indicating that the microstructural change and the variation of related mechanical properties with straining observed in pure Al are not affected significantly by the methods of SPD processing.